基于不同废污泥源的短程反硝化快速启动及稳定性

为探究不同废污泥源快速启动短程反硝化和实现稳定NO_2~--N积累的可行性,在3个完全相同的SBR反应器(S1、S2和S3)分别接种:实验室城市污水反硝化除磷系统排泥、城市污水厂剩余污泥及河涌底泥,比较其短程反硝化启动快慢和NO_2~--N积累特性,考察系统短程反硝化活性和NO_3~--N→NO_2~--N转化性能,并从微生物学角度分析反应器功能菌群特征.结果表明,在乙酸钠为唯一碳源、高碱度和适宜COD/NO_3~--N比进水条件下,3个SBR短程反硝化反应器在短时间内均能够成功启动,系统平均NO_3~--N→NO_2~--N转化率为S1 S2 S3(75. 92% 73. 36% 69. 90%).同时发现持续低温条件下S1和S2呈现不同程度的短程反硝化性能恶化趋势,但S3能够稳定维持良好NO_2~--N积累性能.微生物高通量测序表明,变形菌门和拟杆菌门居PD系统主导地位,3个短程反硝化反应器NO_2~--N积累关键功能菌属Thauera属丰度差异明显:S3 S1 S2(25. 09% 4. 71% 3. 60%),表明S3具备稳定高效的NO_2~--N积累性能,同时高丰度Thauera属可能是维持低温短程反硝化活性的重要原因.     

固定化微藻流化床反应器去除低碳污水中氨氮的潜力

以固定化微藻颗粒为原料,通过搭建流化床反应器强化微藻对氨氮（NH₄⁺-N）的去除,设计了藻种、污水上升流速、光周期和光照强度四组单一变量实验,系统地研究了不同条件下微藻去除NH₄⁺-N的能力.结果表明,当以固定化斜生栅藻为原料、污水上升流速为6.8m/h、光周期为8：16h和光照强度为4800Lux时,NH₄⁺-N去除效果最优（96.7%）.在最优操作条件下,探究了COD为200mg/L时微藻去除NH₄⁺-N的潜力,结果表明,当NH₄⁺-N初始浓度不高于50mg/L时,NH₄⁺-N去除率高于95%.本实验建立了一套半连续微藻流化床实验方法,该方法显著减弱了微藻在生物同化过程中对有机碳源的依赖性,为低COD条件下微藻生物脱氮工艺的设计提供了技术参考和理论基础.     

雨水管道沉积物中典型无机氮的干期粒径分布

以南京江北新区分流制雨水管道沉积物为研究对象,考察不同粒径沉积物中铵态氮（NH₃-N）和硝态氮（NO₃^--N）干期分布特征,分析其随干期长度的变化关系,并探讨沉积物理化性质及微生物菌群结构对NH₃-N和NO₃^--N干期分布的影响.结果表明：粒径≤0.075mm的沉积物中NH₃-N占比最高（交通区30.8%,商业区36.7%）;交通区粒径≤0.075mm的沉积物中NO₃^--N占比最高（33.0%）,而商业区粒径0.075~0.15mm沉积物中NO₃^--N占比最高（34.4%）;干期长度与交通区0.075~0.15mm粒径段的沉积物中NO₃^--N含量及商业区粒径≥0.3mm的沉积物中NH₃-N含量之间的相关性均最显著;雨水管道沉积物中NH₃-N和NO₃^--N的干期分布与O-H和N-H等官能团、表面极性和亲水性、微观形貌等有一定关联;交通区雨水管道沉积物中Gemmobacter等反硝化优势菌种（相对丰度总和为20.15%）对NO₃^--N干期分布影响更显著.     

纳米涂层/铝合金在不同pH值的海水溶液中的腐蚀行为研究

目的评价纳米涂层/铝合金在不同pH值海水溶液中的腐蚀行为。方法通过测试纳米涂层/铝合金试样在不同pH值海水溶液中的EIS值,分析试样阻抗谱图及Bode谱图的演化规律,建立不同EIS图谱的不同电极阻抗模型,并采用ZView软件解析涂层体系不同时期的电化学阻抗谱,获得涂层电阻的变化趋势,及不同pH值海水浸泡的纳米涂层体系腐蚀失效速度。结果随着浸泡时间的增加及pH值的降低,纳米涂层/铝合金体系腐蚀损伤失效速率在浸泡前期整体趋势增大,但中后期由于腐蚀产物逐渐堵塞了涂层的微孔,腐蚀介质向铝合金表面渗透的速率逐渐减小。结论 pH为2.0海水浸泡下的3涂层失效最快,其次是pH为4.0海水浸泡下的2涂层,最后为p H为6.0海水浸泡下的1涂层,该涂层体系应采用等效电路模型C进行拟合。     

A Global Overview of Atmospheric Acid Deposition Fluxes

This paper presents a summary of globalacid deposition flux data taken from a globalassessment report on acid deposition prepared forUNEP/WMO (Whelpdale and Kaiser, 1996). There is a largevariation in the spacial coverage and reliability ofmonitoring around the world. Many more stationsmeasure wet deposition than collect appropriate datafor estimating dry deposition. The widespread regionswith highest precipitation concentrations anddeposition fluxes of sulphate and nitrate coincideclosely with the regions of highest density ofSO₂ and NO_x precursor emissions occurringprimarily in the mid-latitude, northern hemispherebelt where a large fraction of the worlds fossilfuels is consumed. Organic acids in precipitation makea minor contribution to acidity (<20%) inindustrial regions, but in the rest of the world theyare of same order, or even exceed, inorganic acids.Less is known about dry deposition, but it appears topredominate near strong emission sources with wetdeposition predominating farther downwind. The molarratio of the N/S contribution to acidic deposition isclose to 1.0 over large areas of Europe and NorthAmerica, but is highly variable elsewhere, beinghighest in equatorial regions due to biomass burningand lowest near smelters and other large sources of SO₂.     

甲硫醚废气制取二甲基亚砜技术研究

选择双氧水作氧化剂，将具有恶臭气味的涕灭威生产的副产物甲硫醚氧化成无臭的二甲基亚砜。通过实验，优化了工艺条件，减少了安全隐患，提高了二甲基亚砜的产率，消除了恶臭污染。     

混凝研究中的界面过程化学:IPF-颗粒物-水溶液的相互作用

仅以IPF 颗粒物 水溶液的相互作用为例 ,对混凝研究中二界面过程化学领域的进展加以介绍 .研究结果表明 ,经过预制的聚合铝在混凝过程中表现出较好的形态稳定性 ,而传统混凝剂则强烈地受溶液化学过程 ,尤其是溶液pH值的影响 .混凝剂水解聚合形态倾向于在颗粒物表面吸附沉积 ,而直接引发混凝作用 .单体形态则通过转化为聚合、沉淀形态起混凝作用     

脲酶抑制法检测环境样品中重金属离子研究

为探索利用脲酶快速检测环境样品中重金属离子的最佳条件，系统研究了重金属和缓冲液类型及其浓度对脲酶抑制率的影响。结果表明，不同浓度缓冲液中重金属离子浓度与脲酶抑制率呈显著的相关性，表现为随着重金属离子浓度的增加，脲酶抑制率也提高。缓冲液类型和浓度均能影响重金属对脲酶的抑制作用，其中磷酸缓冲液中，无论是Hg^2 还是Cu^2 对脲酶活性均有较强的抑制作用：在柠檬酸缓冲液中2种离子对脲酶的抑制作用存在显著差异。建立脲酶抑制检测技术的关键是选择合适的缓冲系统。此结果为脲酶抑制法在快速检测重金属离子中最佳检测条件的选择提供了理论依据。     

Insights into the mechanism of the deterioration of mainstream partial nitritation/anammox under low residual ammonium

Residual ammonium is a critical parameter affecting the stability of mainstream partial nitritation/anammox (PN/A), but the underlying mechanism remains unclear. In this study, mainstream PN/A was established and operated with progressively decreasing residual ammonium. PN/A deteriorated as the residual ammonium decreased to below 5 mg/L, and this was paralleled by a significant loss in anammox activity in situ and an increasing nitrite oxidation rate. Further analysis revealed that the low-ammonium condition directly decreased anammox activity in situ via two distinct mechanisms. First, anammox bacteria were located in the inner layer of the granular sludge, and thus were disadvantageous when competing for ammonium with ammonium-oxidizing bacteria (AOB) in the outer layer. Second, the complete ammonia oxidizer (comammox) was enriched at low residual ammonium concentrations because of its high ammonium affinity. Both AOB and comammox presented kinetic advantages over anammox bacteria. At high residual ammonium concentrations, nitrite-oxidizing bacteria (NOB) were effectively suppressed, even when their maximum activity was high due to competition for nitrite with anammox bacteria. At low residual ammonium concentrations, the decrease in anammox activity in situ led to an increase in nitrite availability for nitrite oxidation, facilitating the activation of NOB despite the dissolved oxygen limitation (0.15–0.35 mg/L) for NOB persisting throughout the operation. Therefore, the deterioration of mainstream PN/A at low residual ammonium was primarily triggered by a decline in anammox activity in situ. This study provides novel insights into the optimized design of mainstream PN/As in engineering applications.     

高浓度甲基橙溶液的低压湿式催化氧化处理

以高浓度甲基橙溶液模拟偶氮染料废水,采用低压湿式催化氧化法(LPWCO)进行处理,考察了H2O2投量、温度、FeSO4投量、硫酸浓度、甲基橙浓度等因素对甲基橙脱色率的影响。结果表明,LPWCO法能有效地使高浓度(大于400mg/L)甲基橙溶液脱色,脱色率大于95%,而H2O2投量不到Fenton法的5%。