2013年春夏季莱州湾海水环境要素特征和富营养化评估

根据2013年5（春季）、8月（夏季）莱州湾海水环境要素的调查资料，采用富营养化指数、潜在性富营养化评价模式和灰色聚类分析方法研究环境要素特征和评估海水富营养化状况。结果表明，无机氮是莱州湾水质的主要污染要素，春夏季的N/P平均值分别为100.76、117.84，潜在性富营养化评价模式结果表明，春夏季各站位的营养级均只包括Ⅳ_P、Ⅵ_P两类，磷限制为莱州湾的营养盐结构特征；富营养化指数评价结果表明，春季和夏季E>1站位比例分别为65%、20%；灰色聚类分析结果表明，春季Ⅱ级、Ⅲ级的站位比例分别为95%、5%，夏季Ⅱ、Ⅲ级的站位比例分别为70%、25%，Ⅱ级中的部分站位具有较大潜在富营养化风险。     

Comparative evaluation of sizing of metal hydride (MH) hydrogen storage tank filled with different alloys

This study presents a comparative analysis of sizing of metal hydride tank filled with different alloys. Alloys include solid solutions and intermetallic compounds of the generic families AB₅, AB₂, AB, A₂B. The effects of the different alloys on the sizing of metal hydride hydrogen storage tanks are complicated and depend on many factors. In this paper, a thermoeconomic optimization analysis with a simple algebraic formula was presented for the estimation of optimum metal hydride tank surface area for heat transfer enhancement. The optimum area of the metal hydride tank filled with commercially available different alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) was evaluated and compared by the developed method. The optimum net savings and the value of payback were determined for four alloys. It is found that mathematical model can be employed for the determination of optimum metal hydride tank design and increasing net savings according to alloy types. The optimum areas of the tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) were calculated as 0.136, 0.130, 0.133, and 0.173 m², respectively. The optimum net savings for tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) are about 461.0, 409.3, 419.6, and 979.6 $ and the values of payback are about 1.98, 2.1, 2.17, and 1.37 years, respectively. Excessive area of the metal hydride tank would not be as economical as the optimum tank area. Thermal management of metal hydride tank must be designed for optimum points calculated at which maximum savings occur.     

污水处理厂剩余污泥对凤仙花和万寿菊生长的影响

采用盆栽方式,通过对花卉植物生长状况和各项生理指标的考察,研究了不同污泥施用比对凤仙花(Impatiens balsamina)和万寿菊(Tagetes erecta L.)生长的影响。结果表明,污泥施用比不高于5%(质量分数)时对两种花卉植物发芽有促进作用。在前期,对照组凤仙花和万寿菊生长较好,其株高、叶绿素和可溶性糖含量高于污泥施用组,丙二醛(MDA)含量低于污泥施用组。而在后期,污泥的施用对两种花卉生长促进作用明显,污泥施用组的两种花卉植物株高和各项生理指标优于对照组,尤其是开花状况显著好于对照组。凤仙花和万寿菊较优的污泥施用比分别为3%~5%和1%~5%。     

TiO2气溶胶快速去除空气中的芥子气模拟剂

在自制反应器内,通过喷射法将纳米TiO_2分散成气溶胶形式,用以降解空气中的芥子气模拟剂二乙基硫醚(DES)。利用自行设计的一套气溶胶沉降行为评价装置,对TiO_2气溶胶的释放条件进行了优化。系统研究了相对湿度、反应温度、光强、催化剂加入量、反应物浓度等因素对DES降解速率和彻底矿化速率的影响。结果表明:TiO_2气溶胶对2.80 mg/L(近似芥子气快速致死浓度)DES降解的半衰期由涂覆型TiO_2的34.5 min缩短至8.5 min;TiO_2气溶胶光催化降解DES的最佳相对湿度为35%,此时CO_2最快生成速率可达34.64μg/(L·min),150 min内彻底矿化比例达66.1%;对于1.5 L反应器,催化剂加入量为30 mg时降解DES的量效比达到最佳状态;TiO_2气溶胶光催化适用于含低浓度DES空气的快速净化。     

A hybrid decision-making approach based on FCM and MOORA for occupational health and safety risk analysis

IntroductionWith the development of industries and increased diversity of their associated hazards, the importance of identifying these hazards and controlling the Occupational Health and Safety (OHS) risks has also dramatically augmented. Currently, there is a serious need for a risk management system to identify and prioritize risks with the aim of providing corrective/preventive measures to minimize the negative consequences of OHS risks. In fact, this system can help the protection of employees’ health and reduction of organizational costs. Method: The present study proposes a hybrid decision-making approach based on the Failure Mode and Effect Analysis (FMEA), Fuzzy Cognitive Map (FCM), and Multi-Objective Optimization on the basis of Ratio Analysis (MOORA) for assessing and prioritizing OHS risks. After identifying the risks and determining the values of the risk assessment criteria via the FMEA technique, the attempt is made to determine the weights of criteria based on their causal relationships through FCM and the hybrid learning algorithm. Then, the risk prioritization is carried out using the MOORA method based on the decision matrix (the output of the FMEA) and the weights of the criteria (the output of the FCM). Results: The results from the implementation of the proposed approach in a manufacturing company reveal that the score at issue can overcome some of the drawbacks of the traditional Risk Priority Number (RPN) in the conventional FMEA, including lack of assignment the different relative importance to the assessment criteria, inability to take into account other important management criteria, lack of consideration of causal relationships among criteria, and high dependence of the prioritization on the experts’ opinions, which finally provides a full and distinct risk prioritization.     

Nitrogen evolution during the co-combustion of hydrothermally treated municipal solid waste and coal in a bubbling fluidized bed

Nitrogen evolution was studied during the co-combustion of hydrothermally treated municipal solid wastes (HT MSW) and coal in a bubbling fluidized bed (BFB). HT MSW blending ratios as 10%, 20% and 30% (wt.%) were selected and tested at 700, 800, 900 °C. Emissions of NO and N₂O from blends were measured and compared with the results of mono-combustion trials. Moreover, concentrations of precursors like NH₃ and HCN were also quantified. The results are summarized as follows: NO emissions were predominant in all the cases, which rose with increasing temperature. The blending of HT MSW contributed to the NO reduction. N₂O emissions decreased with temperature rising and the blending of HT MSW also presented positive effects. At 30% HT MSW addition, both NO and N₂O emissions showed the lowest values (391.85 ppm and 55.33 ppm, respectively at 900 °C). For the precursors, more HCN was detected than NH₃ and both played important roles on the gas side nitrogen evolution.     

5种植物材料的水解释碳性能及反硝化效率

碳源在硝酸盐去除过程中起电子供体的作用,是生物反硝化反应的关键物质之一。为解决污水处理脱氮时碳源不足抑制反硝化反应造成脱氮效率低的问题,本研究选取风车草、甘蔗渣、芦竹、美人蕉和稻草秆5种植物材料作为反硝化碳源,探讨不同植物材料的水解释碳能力和释放规律;并进一步以其水解液作为外加碳源,探讨其对反硝化脱氮效率的影响。研究结果表明,植物材料水解释碳过程符合二级动力学反应规律,不同植物材料的释碳能力具有显著性差异,以甘蔗渣在固液比1∶80时COD释放当量最大,为45.45 mg/L;添加植物水解液可显著提高反硝化脱氮效率,以芦竹水解液脱氮效果最好,达到71.9%。此外,碳氮比是影响脱氮效率的重要因素之一,以碳氮比为9时反硝化脱氮效果最佳。     

厌氧系统中碱处理对污泥减量的影响

碱解预处理污泥和原污泥按一定比例进行混合后,投入厌氧反应器中进行消化,研究其对污泥减量化的影响。结果表明,该处理既可以提高污泥减量率,又能改善污泥厌氧消化性能,提高污泥产气量。当碱处理污泥和原污泥混合比为1∶3时,在混合初期由于稀释作用和水解中和作用,溶液的pH能迅速恢复到中性。SS减少48%,较对照组提高了10%;SCOD减少约80%,较对照组提高20%,而空白对照组因未发生溶胞作用,各参数值均处于较低水平,降解率也维持在较低水平。     

磷石膏水热法合成硫酸钙晶须

以磷石膏为原料，二水合硫酸钙、硫酸镁、甘油为添加剂，采用水热法合成硫酸钙晶须，考察了料浆含量、反应温度、反应时间、体系pH等因素对晶须的直径和长径比的影响；并采用SEM技术观察硫酸钙晶须的形貌。实验结果表明，当磷石膏含量2.5%（w）、反应温度130 ℃、反应时间4 h、体系pH 4时，制备得到的硫酸钙晶须长径比为56.24，平均直径为0.17 μm。SEM表征结果显示，硫酸钙晶须形貌规整、分散均匀、直径较小，达百纳米级。     

Forensic Evaluation of Metals (Cr,Cu, Pb,Zn), Isotopes (δ13C and δ15N), and C:N Ratios in Freshwater Sediment

A forensic approach was used to evaluate sediments from Portão Stream, including analysis of metals, carbon (C) and nitrogen (N) stable isotopes, and C:N ratios. Samples collected at various points located along the stream were tested in order to investigate a possible illegal leachate input. The studied stream is heavily impacted by sewage and industrial discharges from two cities along its course. Among the metals analyzed, chromium (Cr) was noticeably the main pollutant, showing the highest levels, above regulatory limits, downstream from some potential sources of effluents enriched with this metal. Isotope analyses revealed a general trend of depletion in the heavier isotope along the stream for C and N. The exception was one point near a hazardous waste landfill, where relatively more enriched δ¹³C and δ¹⁵N values were found. The isotope and metal analysis results indicated that this site was affected by a particular source, demonstrating the combination of these parameters could be used for the discrimination of sources in a heavily polluted stream. Nevertheless, further investigations are necessary to provide a comprehensive evaluation of the biogeochemical processes involved in the incorporation of leachate in sediments to use this analysis as evidence for the illegal leachate discharge.