Determination of alkali-labile phosphoprotein phosphorus from fish plasma using the Tb^3＋-tiron complex as a fluorescence probe

A sensitive method based on the fluorescence quenching effect of the Tb^3＋-Tiron complex is proposed for the determination of alkali-labile phosphoprotein phosphorus （ALP） released from fish plasma. The detection limit was 5.4 ng/ml （S/N=2）, and the relative standard deviation of the quenching effect （6 replicates） was 4.6%. The results obtained by the proposed method were in good agreement with those obtained by the colorimetric assay. The advantages of the present method are its relatively simple detection procedure, the lack of toxic organic solvents, and high sensitivity.     

实车三效催化剂表面成分分析

对主要在北京行驶的总里程在34×104～59×104km的6辆轻型出租车用三效催化剂,利用X射线荧光光谱仪(XRF)分析了其表面元素的种类、含量,以及污染物元素含量与行驶里程的关系.结果表明,在催化剂表面检测到的元素种类近30种,含量较高的元素种类基本相同.前后级催化剂上检测到的共同污染物元素有P、Ca、Zn和Mn等,主要来自于机油和汽油,34×104km行驶里程后,P在催化剂的累积速度已非常缓慢,Ca、Zn和Mn在催化剂表面的沉积经过56×104km后仍有增加的趋势.在后级催化剂上还检测到了明显的S含量,说明S更容易在后级催化剂上沉积.经过40×104km行驶里程后,S在催化剂表面的沉积量基本达到平衡状态.累积规律说明经过40×104km行驶里程后,容易使催化剂中毒的P和S对催化剂活性影响已较小,而Ca、Zn和Mn的持续累积,将会继续降低催化剂的活性.     

C/P对EBPR系统PAOs与GAOs竞争及PHAs代谢过程影响研究

以富含聚磷菌(PAOs)活性污泥为基础,基于FISH技术研究了SBR工艺不同C/P(25∶1、20∶1、15∶1和10∶1)对EBPR系统中功能菌变化特征与微生物胞内聚合物(PHAs)代谢过程的影响.结果表明,经过10 d运行处理,C/P分别为25∶1、20∶1和15∶1系统磷酸盐去除率88%,而C/P为10∶1系统磷酸盐的去除率为0%.FISH检测结果显示,随着C/P从25∶1下降到10∶1,EBPR系统中PAOs的含量相应从(76.42±1.24)%减少到(10.40±0.97)%,而聚糖菌(GAOs)则从(16.36±3.41)%增加到(34.25±2.59)%.在厌氧段,不同C/P条件下EBPR系统中PHB和PHV的合成动力学系数大小分别为K25∶1K20∶1K15∶1K10∶1和K15∶1K20∶1K25∶1K10∶1.随着C/P从25∶1下降到10∶1,合成PHB在PHAs中所占的比例从85%下降到24%,而PHV则从15%上升到76%;在好氧段,不同C/P系统消耗PHB和PHV的动力学系数大小均为K20∶1K25∶1K15∶1K10∶1,且C/P为25∶1、20∶1和15∶1时系统消耗主要成分是PHB(占PHAs 71%～75%),而C/P为10∶1时系统消耗主要成分是PHV(占PHAs 71%).由此表明,随着C/P的降低,EBPR系统内GAOs增加而PAOs减少,从而导致系统内PHB合成与消耗比例逐渐减少,而PHV合成与消耗比例逐渐增加.     

荧光桃红-溴化十六烷基三甲基铵检测有机磷农药残留总量

在pH为6.40的B-R缓冲溶液中,荧光桃红与一定浓度的溴化十六烷基三甲基胺发生荧光增强反应,加入有机磷农药后,体系的荧光强度降低,且降低程度与有机磷农药的加入量呈良好的线性关系,建立了用此荧光法来测定有机磷农药残留总量的新方法.在优化试验条件下,线性范围为0.008-0.72 mg·L-1,检出限为0.05 mg·L...     

利用X射线吸收近边结构光谱(XANES)研究水泥窑共处置产品中Ni和Cd的微观组成

在模拟水泥窑中高温煅烧掺有Ni、Cd化学试剂的水泥生料,并由制取的水泥熟料制备水泥净浆片.利用X射线吸收近边结构光谱（XANES）对水泥窑共处置产品中Ni、Cd的微观组成进行了研究.结果表明：Ni在水泥窑煅烧过程中发生了较为彻底的化学变化,形成了Ni-Mg化合物,该化合物可能是以氧化物、氢氧化物或碳酸盐的形式存在;水泥...     

Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

Fabrication and photoelectrocatalytic properties of nanocrystalline monoclinic BiVO4 thin-film electrode

Monoclinic bismuth vanadate(BiVO4) thin film was fabricated on indium-tin oxide glass from an amorphous heteronuclear complex via dip-coating.After annealation at 400,500,and 600°C,the thin films were characterized by X-ray diffraction,field emission scanning electron microscopy,X-ray photoelectron spectroscopy,and UV-Vis spectrophotometry.The BiVO4 particles on the ITO glass surface had a monoclinic structure.The UV-Visible diffuse reflection spectra showed the BiVO4 thin film had photoabsorption propertie...     

Effects of metal cations on sorption-desorption of p-nitrophenol onto wheat ash

The mutual e ects of metal cations (Cu2+, Pb2+, Zn2+, and Cd2+) and p-nitrophenol (NP) on their adsorption desorption behavior onto wheat ash were studied. Results suggested that Cu2+, Pb2+, and Zn2+ diminished the adsorption and increased the desorption of NP remarkably, while Cd2+ had no such e ect. In contrast, NP diminished the adsorption of Cu2+, Pb2+, and Zn2+ onto ash, however, this suppression e ect depended on the initial concentrations of metal cations. NP had no e ect on Cd2+ adsorption on ash. Fourier transform infrared (FT-IR) and X-ray absorption spectroscopic (XAS) studies suggested the following mechanisms responsible for the metal suppression e ect on NP adsorption: (1) large hydrated Cu2+, Pb2+, and Zn2+ shells occupied the surface of ash and prevent nonspecific adsorption of NP onto ash surface; (2) Cu2+, Pb2+, and Zn2+ may block the micropores of ash, resulting in decreased adsorption of NP; (3) complexation of Cu2+, Pb2+, and Zn2+ was likely via carboxyl, hydroxylic and phenolic groups of wheat ash and these same groups may also react with NP during adsorption. As a “soft acid”, Cd2+ is less e cient in the complexation of oxygencontaining acid groups than Cu2+, Pb2+, and Zn2+. Thus, Cd2+ had no e ect on the adsorption of NP on wheat ash.     

Resistance and biosorption mechanism of silver ions by Bacillus cereus biomass

Biosorption of silver ions onto Bacillus cereus biomass was investigated. Overall kinetic experiments were performed for the determination of the necessary contact time for the attainment of equilibrium. It was found that the overall biosorption process was best described by pseudo second-order kinetic model. The crystals detected by scanning electron microscope and X-ray photoelectron spectroscopy suggested the precipitation was a possible mechanism of biosorption. The molecular genetics of silver resistance of B. cereus biomass was also detected and illustrated by a whole cell sensor tool.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.