二氧化钛脱除高温烟气中的氯化氢

HCl是城市垃圾焚烧产生的主要气体污染物之一。将一种新型脱氯剂TiO2引入到垃圾焚烧系统中,并与其他脱氯剂的性能进行比较。研究了不同脱氯剂使用量、不同反应温度和不同HCl气体浓度对TiO2、CaO和CaTiO3脱氯效果的影响。结果显示,TiO2能在高温(800~1 000℃)、高HCl浓度(1 303.6~1 629.5 mg/m3)下获得较好的脱氯效果。与传统的脱氯剂CaO相比,TiO2更适合于高温烟气脱氯,其在1 000℃时的氯容(36.3 mg HCl/g TiO2)几乎是相同情况下的CaO氯容(9.3 mg HCl/g CaO)的4倍。而CaTiO3的脱氯效果不但受到自身分解效率的影响,还受到TiO2和CaO脱氯效果的影响,其脱氯效果较差。     

Mg3MnxAl1-xCO3类水滑石衍生NSR催化剂的制备及其性能评价

采用共沉淀法合成了三元类水滑石Mg_3Mn_xAl_(1-x)CO_3,通过高温煅烧得到其衍生氧化物Mg_3Mn_xAl_(1-x)O_m,再经浸渍负载Pt或BaO后制得新型NO_x存储/再还原(NSR)催化剂。XRD及SEM表征结果显示,当Mn与Al的摩尔比(Mn/Al)大于1时所制备的Mg_3Mn_xAl_(1-x)O_m有杂晶相出现且发生团聚,结合NO_x存储性能评价结果,确定最优Mn/Al为1。BaO负载不利于NO_x的存储,而当Pt负载量为1%(w)时NO_x存储性能最优,250℃条件下的存储量由负载前的0.52 mmol/g提升至0.61 mmol/g。CO_2与NO_x之间存在较强的竞争吸附。负载1%Pt催化剂的NSR性能评价结果表明,8个稀燃-富燃循环后NO_x的去除率为68%,表明催化剂的还原性能仍需加强。     

浅谈爆破振动的控制措施

结合爆破振动的作用机理,分别对减少振源爆炸能量、干扰降振、阻断振动波传播途径、控制爆破规模、合理选择分段间隔时间等爆破振动主要控制措施进行了分析讨论。并根据实际施工情况分析了通过电子雷管实现干扰降振的减振效果,为类似工程提供借鉴作用。     

大型碳化硅生产园区面源源强及减排指标核算

以某年产25万吨大型碳化硅园区无组织排放面源为例,提出基于多个地面站气象数据的CALPUFF模型地面浓度反推方法,优化流场模拟,使得无组织面源源强核算结果更加准确,并以环境保护目标空气质量达标为原则,核算其大气污染物减排指标,得出具体结论:园区大气污染物SO2、NOX、CO、PM10年排放量分别为449.06t、86.98t、5158.58t、115.06t;无组织排放SO2、CO及PM10的减排比例分别为63.5%、19.2%、42.44%,对应减排量分别为285.16 t/a、990.45 t/a、48.83 t/a。     

What happened to the Second World? Earthquakes and postsocialism in Kazakhstan

There is an assumption that with the disintegration of the Soviet Union, the Second World ceased to exist. Yet the demise of the Communist bloc as a geopolitical reality did not mean that it stopped exerting a defining influence over how people think and behave. This article examines how the postsocialist state in Kazakhstan deals with potential crises such as earthquakes and the extent to which the Soviet legacy still shapes intellectual debates, state structures, and civil society organisations in in that country. Drawing on fieldwork and interviews, this paper re-examines the Second World in its historical context and re-establishes it as a conceptual framework for considering disaster risk reduction in the former Soviet bloc. It argues that it is essential to pay attention to this legacy in Kazakhstan both in policy and practice if earthquake risk reduction is to be made more effective.     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

基于LCA的废旧资源循环利用节能减排效果评估模式与方法研究——以吉林省某钢铁企业为例

促进废旧资源循环利用是加快推进我国生态文明建设,完成节能减排目标的必然选择。本文基于生命周期评价模式,从微观企业层面入手,构建产品全生命周期基准流程,引入能量输入与环境输出参数,建立废旧资源循环利用节能减排效果量化核算模型,评估再生产品的节能减排经济成效,并以吉林省某钢铁企业为例,评估"废钢-电炉"短流程和"铁矿石-高炉-转炉"长流程的能源、环境、成本差异,辨识影响废钢再循环节能减排效果的主要因素和重要环节。结果显示,再生钢铁全生命周期与原生钢铁全生命周期相比,节能588.48kgce/t,节能率为84%;主要污染物中SO2减排率最高,达92%;CO2总减排1 180.92 kg/t,减排率为67%;总成本却高出198元/t。其中,炼铁工序的节能量和减碳量最大,烧结工序SO2、NOx和烟(粉)尘减排量最大,焦化工序COD和氨氮减排量最大,回收、加工处理、炼钢环节节能量和减碳量以及SO2、NOx和烟(粉)尘减排量均为负。成本方面,再生钢铁生产成本高于原生钢铁308元/t,虽然再生钢铁由于污染减排可节省56元/t的排污费并获取54元/t的碳交易收益,但都不足以扭转电炉炼钢费用较高的现状。因此,国家应在电炉炼钢方面给予钢企及相关企业适当的财税扶持政策,在电价方面给予钢企一定的优惠或补贴,并完善废钢回收加工体系等,以促进废钢循环利用。基于LCA的废旧资源循环利用节能减排效果评估可以实现对产品生命周期全过程的资源、环境、成本的优化管理。     

羟基乙叉二膦酸镀铜废液的处理及Cu~(2+)的高附加值资源化回收

采用Na BH4还原法将羟基乙叉二膦酸(HEDP)镀铜废液中的Cu~(2+)制备成纳米铜粉,并采用聚丙烯酰胺(PAM)对还原反应后的废液进行絮凝处理。研究了n(Cu~(2+))∶n(Na BH4)、还原反应温度、还原反应时间及PAM添加量对废液中剩余Cu~(2+)质量浓度的影响,并对回收的纳米铜粉进行了XRD和TEM表征。实验结果表明:当n(Cu~(2+))∶n(Na BH4)=4∶6、还原反应温度为50℃、还原反应时间为2 h时,废液中剩余Cu~(2+)质量浓度降低至1.1 mg/L,Cu~(2+)还原率达99.99%;可获得粒径为20~45 nm的近球型、高纯度、由多晶组成的纳米铜粉;当PAM添加量为10 mg/L时,废液中剩余Cu~(2+)质量浓度降至0.35 mg/L以下,达到GB 21900—2008《电镀污染物排放标准》(小于0.5 mg/L)的要求。     

厌氧系统中碱处理对污泥减量的影响

碱解预处理污泥和原污泥按一定比例进行混合后,投入厌氧反应器中进行消化,研究其对污泥减量化的影响。结果表明,该处理既可以提高污泥减量率,又能改善污泥厌氧消化性能,提高污泥产气量。当碱处理污泥和原污泥混合比为1∶3时,在混合初期由于稀释作用和水解中和作用,溶液的pH能迅速恢复到中性。SS减少48%,较对照组提高了10%;SCOD减少约80%,较对照组提高20%,而空白对照组因未发生溶胞作用,各参数值均处于较低水平,降解率也维持在较低水平。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺，氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时，在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下，处理后废酸中的氯离子质量浓度为0.22 g/L，氯离子去除率为98.59%，铜离子质量浓度为0.45 g/L，铜离子去除率为95.08%，其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。