云南抚仙湖流域磷化工对农田土壤和农作物的影响

通过对云南抚仙湖流域磷化工厂附近农田和区域内地表径流污染物含量进行调查分析,结果表明距磷化工厂越近,农田灌溉水、土壤、农作物中污染物含量越高。磷化工生产排放的废水和废渣淋溶废水严重污染了附近农田灌溉水,从而造成农田土壤氟、磷积累,最高分别超过对照农田土壤氟、磷含量35和37倍。相关分析结果表明农作物茎、叶蓄积的高浓度氟、磷主要来源于受磷化工排放废水和废渣污染的农田土壤。     

活化铁锰结核的除氟性能研究

通过批实验研究接触反应时间、温度、共存阴离子对除氟效果的影响.结果表明,接触反应时间为48 h时,吸附都将近平衡.温度越高,越有利于氟离子的吸附.Langmuir和Freundlich吸附等温模式都可以较好地描述氟离子的吸附特性.热力学分析发现活化铁锰结核对氟的吸附为自发的吸热反应.当其他阴离子存在时,会对吸附造成不利影响.柱实验结果表明,活化铁锰结核动态除氟效果很好,性能稳定,机械强度高,易洗脱再生,且洗脱再生后饱和吸附量明显增大.出水中铁、锰含量不超过我国生活饮用水卫生标准.用Thomas模型分析,得到的平均饱和吸附量可达1.340 mg/g.X射线衍射和扫描电镜分析表明,经FeCl3活化的铁锰结核表面附着大量铁的氧化物或氢氧化物.这些铁的氢氧化物或氧化物对水中氟离子的去除起重要作用.     

氧化铝负载镧去除水中F-的研究

通过固相反应合成了氧化铝负载的氧化镧吸附剂并研究了其对水中F-的吸附.结果表明.合成的材料对F-有很好的去除效果,最大吸附量达到53.4 mg·g-1;适当提高吸附温度和氧化镧负载量都能在一定范围内提高吸附量;较低的固相反应焙烧温度有利于提高去除率,随着焙烧温度的升高,吸附量从170℃焙烧的42.2 mg·g-1下降到了350℃焙烧的32.9 mg·g-1.同时,吸附剂表现出了很好的适应性,在较宽的pH范围内都能保持较高的吸附量.     

包头市大气氟化物排放总量控制管理研究

结合实践,阐述了总量控制管理的必要性和可能性;介绍和分析了总量管理的内容和程序;对主要问题提出对策和措施;形成运行管理机制,提出排氟量计算、污染物输送扩散模型等构成的技术支持系统。      

不同日摄氟量居民罹患氟斑釉的研究

人和动物体内的硬组织（牙齿、骨骼等）是氟化物作用的主要部位,严重者可引起氟骨症和氟斑釉,其中氟斑釉是慢性氟中毒的一项特异指标。通常日摄氟量高的居民其氟斑釉率和斑釉指标均增高。本文用日摄氟量作指标评价环境氟对居民牙齿的影响。研究结果揭示,当地居民的斑釉率和斑釉指数均与日摄氟量呈非常显著的正相关,r＝0.9084,P<0.01。     

高效液相色谱法测定茶叶和土壤中的氟

建立了测定氟的高效液相色谱法,并通过加入三乙胺使Ｆ－Ｌａ＾３＋－苯素氨羧络合剂体系更稳定。Ｃ１８柱,甲醇－水（１８：８２）作流动相,流速为１ｍｌ／ｍｉｎ,检测波长为５６６ｎｍ,本法线性范围为０．０１０－１．０μｇ／ｍｌ,相关系数为０．９９１,检出限为１ｎｇ／ｍｌ,用于茶叶和土壤样品测定时,相对标准偏差为４．６％－７．３％,加标回收率为９１％￣１０４％。     

用氟化钾水溶液从制药废液中回收吡啶

研究了普通精馏与加盐分相技术在回收吡啶中的应用。测定了吡啶 水 氟化钾体系在25℃时的液液相平衡数据,采用Pitzer理论和UNIQUAC方程对相平衡数据进行了理论计算,结果表明计算值与实验值符合良好。采用氟化钾水溶液回收吡啶,当60%氟化钾浓溶液与50%吡啶/50%水的物料的质量比为2.0时,有机相中吡啶的纯度可达到92.60%(质量分数),水相中氟化钾稀溶液经蒸发回收后循环使用不影响分离性能。该工艺的开发成功为制药行业从制药废液中回收吡啶开辟了一条新途径。     

流动注射分光光度法测定水中痕量氟化物

研究并建立了测定水中痕量氟化物的氟试剂（ＡＬＣ）－流动注射分光光度法。将水样注入到水载流中,与ＡＬＣ－Ｌａ丙酮水溶液混合,在５０℃时反应生成蓝色三元络合物,在分光光度计上于波长６１８ｍｍ处进行检测。Ｆ＾－测定的线性范围为０．０４－３．０ｍｇ／Ｌ,检出限为０．０３６ｍｇ／Ｌ。     

Hydrochemistry of drinking water sources and water purifiers in relation to epidemiological study in Hisar,North-West India

The concern related to the drinking of reverse osmosis (RO) water containing low levels of minerals is growing day by day. This study involves the analysis of water samples from various drinking water sources in a rural site, Mirchpur village, an Indus Valley civilization site (grid location: 29° 18′ 42.3″ N, 76° 10′ 33.0″ E) of Hisar, India, along with the health survey of human subjects. The hydrochemistry of water collected from hand pumps, river canals, tube wells, submersibles, and the RO systems installed in various homes was explored for pH, EC, TH, TDS, turbidity, cations (Na⁺, Ca²⁺, Mg²⁺), anions (CO₃²⁻, HCO₃⁻, Cl⁻, SO₄²⁻, NO₃⁻, F⁻), and elements (Fe, Pb, Se) employing the ion chromatography, flame photometry, and ICP-AES techniques. Lead (Pb) and Selenium (Se) were detected in trace amounts (0.30–2.6 μg L⁻¹; 0.10–4.1 μg L⁻¹, respectively) in all the samples, including the samples collected from RO purifiers, but Iron (Fe) was not detected in RO samples even in trace amounts. The F-levels in hand pump water (HPW) and submersible water (SW) (1.9  and 1.7 mg L⁻¹, respectively) and TDS levels in SW (3048 mg L⁻¹) were found to be above WHO and BIS safe limits. TDS levels in the river canal (900 mg L⁻¹), tube well (1104 mg L⁻¹), hand pump (1170 mg L⁻¹), and submersible samples (3048 mg L⁻¹) were found significantly higher as compared to the RO personal water (ROPW; 216 mg L⁻¹) and RO supply water (ROSW; 90 mg L⁻¹). The collected epidemiological data reveals that 21%, 19%, 13%, and 12% of natives reported skin, kidney, hair fall, liver, and stomach issues, respectively, suspecting the crucial role of high TDS and fluoride levels in the area. This study also provides a comparison between the quality of RO and the direct supply water, along with correlation matrices for different parameters, which gives a rationale for the limitations of drinking direct supply water without any purification and RO water containing low mineral content.     

Effect of biocides on the precipitation of calcium fluoride in the presence of anionic copolymeric inhibitors

The inhibitory efficiency of anionic copolymers and the effect of the biocides sodium hypochlorite, glutaraldehyde, and tris(hydroxymethyl)nitromethane on the precipitation behavior of calcium fluoride (CaF₂) were studied. The efficiency of polymeric inhibitors was traced from conductivity measurements by using half-life (t_1/2) method. X-ray diffraction parameters have been measured for calcium fluoride scale minerals. An anionic copolymer (K-798) acts as one of the best inhibitors for the precipitation process of the calcium fluoride in water as compared to K-775. It is assigned to the fact that the copolymer (K-798) contains both sulfonic acid and sulfonated styrene groups while the polymer (K-775) having only the sulfonic acid group. It was further observed that the biocides have no appreciable effect on the performance of the anionic polymeric inhibitors.