电感耦合等离子体原子发射光谱法(ICP-AES)测定磷生铁中的Mn、P、Si

建立了电感耦合等离子体原子发射光谱（ICP-AES）法测定磷生铁中3种元素Mn、P、Si的定量分析方法.通过试验选择257.610nm、185.942nm、212.412nm分别作为Mn、P、Si的分析谱线,无需进行光谱干扰校正.实验结果表明,各元素分析谱线线性相关系数大于0.9990.方法用于高磷铸铁标准物质分析,测定值与认定值相符,测定结果的相对标准偏差在0.21％ （Mn） ～1.8％ （P）范围.     

比值-导数光谱法快速测定香草醛

文章用比值—导数光谱法测定香草醛的含量。实验结果表明,香草醛木素溶液在pH≤7时香草醛在230 nm处有吸收,在pH>7时在248 nm处有吸收。根据不同pH值和不同浓度条件下香草醛木素溶液的比值-导数光谱,说明在230 nm处的光谱信号在pH≤7不受pH值影响,248 nm处的光谱信号在pH>7不受pH值影响。在230 nm和248 nm处的光谱信号对浓度的变化较为敏感,在此两处吸收值可用于香草醛的测定。     

Heavy metal bioaccumulation in selected medicinal plants collected from Khetri copper mines and comparison with those collected from fertile soil in Haridwar,India

Heavy metal distribution in medicinal plants is gaining importance not only as an alternative medicine, but also for possible concern due to effects of metal toxicity. The present study has been focused on emphasizing the heavy metal status and bioaccumulation factors of V, Mn, Fe, Co, Cu, Zn, Se (essential metals) and Cr, Ni, Cd, As and Pb (potentially toxic metals) in medicinal plants grown under two different environmental conditions e.g., near to Khetri copper mine and those in fertile soils of Haridwar, both in India, using Instrumental Neutron Activation Analysis (relative method) and Atomic Absorption Spectrometry. The copper levels in the medicinal plants from Khetri were found to be 3-4 folds higher (31.6–76.5 mg kg^?1) than those from Haridwar samples (7.40–15.3 mg kg^?1), which is correlated with very high copper levels (763 mg kg^?1) in Khetri soil. Among various heavy metals, Cr (2.60–5.92 mg kg^?1), Cd (1.47–2.97 mg kg^?1) and Pb (3.97–6.63 mg kg^?1) are also higher in concentration in the medicinal plants from Khetri. The essential metals like Mn (36.4–69.3 mg kg^?1), Fe (192–601 mg kg^?1), Zn (24.9–49.9 mg kg^?1) and Se (0.13–0.91 mg kg^?1) and potentially toxic metals like Ni (3.09–9.01 mg kg^?1) and As (0.41–2.09 mg kg^?1) did not show much variations in concentration in the medicinal plants from both Khetri and Haridwar. The medicinal plants from Khetri, e.g., Ocimum sanctum, Cassia fistula, Withania somnifera and Azadirachta Indica were found rich in Ca and Mg contents while Aloe barbadensis showed moderately high Ca and Mg. Higher levels of Ca-Mg were found to correlate with Zn (except Azadirachta Indica). The bioaccumulation factors (BAFS) of the heavy metals were estimated to understand the soil-to-plant transfer pattern of the heavy metals. Significantly lower BAF values of Cu and Cr were found in the medicinal plants from Khetri, indicating majority fraction of these metals are precipitated and were immobilized species unsuitable for plant uptake. Overall, Withania somnifera (Ashwagandha) showed very high metal bioaccumulation.     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.     

运用三维荧光光谱解析高温厌氧产氢反应过程对温度变化的响应

为建立反应器运行状态的荧光光谱快速监测方法,应用三维荧光光谱表征了高温厌氧反应器的出水,采用平行因子分析方法分析后得到3种荧光组分——蛋白质、辅酶NADH和核黄素,并获得它们的激发发射光谱图及相对浓度.结果表明,当温度从50 ℃上升到60 ℃的过程中,3种荧光物质的相对浓度均呈现相应的变化,它们与反应器的运行参数呈现明显相关性.进一步研究表明,核黄素是高温厌氧产氢反应中的特有荧光物质,采用标准加入法和二阶校正方法可以测定其实际浓度,出水中核黄素浓度变化范围为0.04~0.13 mg·L^-1.该研究为厌氧产氢反应器的运行监控提供了理论基础.     

改进测定水中氨氮分子吸收光谱法的试验研究

水中氨氮含量是反应水质状况的重要指标。文章对测定水中氨氮气相分子吸收光谱法(标准号HJ/T195-2005)进行了改进试验研究。第一,对氧化剂的配比进行了改进,使氨氮的测定范围扩展至100μg。第二,对标准HJ/T195-2005中直接使用亚硝酸钠标准溶液做标准曲线的处理方式也做了探讨。通过一系列对比实验认为,应用硫酸铵标准溶液做工作曲线更加准确合理。最后应用改进后的气相分子吸收光谱法和纳氏比色法或滴定法对多种实际废水样品进行同时测定。结果表明,改进后的气相分子吸收光谱法测定氨氮的范围更宽,灵敏度更高和准确度更好。     

重金属离子与依诺沙星相互作用的荧光光谱法研究

荧光分析法是利用物质的荧光性质对物质进行分析的方法,文章应用荧光法研究了不同温度下重金属离子Cu2+、Pb2+及Mn2+与喹诺酮类药物依诺沙星(ENX)的相互作用。结果表明:Cu2+、Pb2+及Mn2+对ENX内源荧光的猝灭机制属于形成复合物所引起的静态猝灭,利用Stern-Volmer关系式计算了ENX与重金属离子Cu2+、Pb2+及Mn2+之间的猝灭常数KSV及结合位点数,根据热力学参数(自由能变ΔG、焓变ΔH、熵变ΔS)确定了ENX与重金属离子之间的主要作用力类型为静电作用力。该研究为探讨环境中重金属离子与ENX的作用机理和环境效应提供了理论依据。     

Biological sulfate removal from acrylic fiber manufacturing wastewater using a two-stage UASB reactor

A two-stage UASB reactor was employed to remove sulfate from acrylic fiber manufacturing wastewater. Mesophilic operation (35±0.5℃) was performed with hydraulic retention time (HRT) varied between 28 and 40 hr. Mixed liquor suspended solids (MLSS) in the reactor was maintained about 8000 mg/L. The results indicated that sulfate removal was enhanced with increasing the ratio of COD/SO₄^2-. At low COD/SO₄^2-, the growth of the sulfate-reducing bacteria (SRB) was carbon-limited. The optimal sulfate removal efficiencies were 75% when the HRT was no less than 38 hr. Sulfidogenesis mainly happened in the sulfate-reducing stage, while methanogenesis in the methane-producing stage. Microbes in sulfate-reducing stage performed granulation better than that in methane-producing stage. Higher extracellular polymeric substances (EPS) content in sulfate-reducing stage helped to adhere and connect the flocculent sludge particles together. SRB accounted for about 31% both in sulfate-reducing stage and methane-producing stage at COD/SO₄^2- ratio of 0.5, while it dropped dramatically from 34% in sulfate-reducing stage to 10% in methane-producing stage corresponding to the COD/SO₄^2- ratio of 4.7. SRB and MPA were predominant in sulfate-reducing stage and methane-producing stage respectively.     

石墨烯薄膜原子氧剥蚀行为及电阻特性

目的研究石墨烯薄膜在原子氧空间环境的适应性,为其在航天器上应用提供参考。方法采用刮涂法制备石墨烯薄膜,将石墨烯薄膜材料及石墨烯电阻传感器置于微波源原子氧设备内开展原子氧试验,原子氧剂量分别为3.0×10^20 atoms/cm2和7.5×10^20 atoms/cm^2,研究薄膜表面形貌、结构、成分及电阻性能的变化。结果采用刮涂法可制备氧含量较低的石墨烯薄膜,原子氧剂量为7.5×10^20 atoms/cm^2情况下,石墨烯薄膜的厚度损失为5.3μm,原子氧反应率为7.14×10^-25 atoms/cm^3。原子氧作用后,石墨烯薄膜中碳原子无序程度增大,C—O、—COOH官能团含量降低,C=O官能团含量增加。石墨烯电阻传感器的R0/R比值随原子氧剂量增加线性降低,0.8μm厚度薄膜可探测最大原子氧剂量为5×10^19 atoms/cm^2,增加薄膜厚度有望提高传感器的使用寿命。结论得到了石墨烯薄膜厚度损失、原子氧反应率、微观结构及电阻特性的变化规律,可为石墨烯薄膜的空间应用提供技术支撑。