机动车排气检验机构的环境影响评价研究

机动车排气定期检验机构对周边环境质量的影响虽然不大,但由于大多处在闹市区,贴近敏感人群,其噪声与机动车尾气对市民的影响却不容忽视。通过环境影响评价,分析机动车排气定期检验机构的环境影响特点,并结合机动车排气定期检验业务流程,对机动车排气定期检验机构的整体规划与布局提出合理建议,对噪声与大气污染物排放提出有效控制措施,不仅可以有效控制机动车排气定期检验机构对周边大气环境质量的影响,也能有效减小噪声对周边市民日常生活的影响。     

用电解锰阳极泥和含SO_2工业尾气制备硫酸锰

以电解锰阳极泥与电解锌生产中产生的含SO_2尾气为原料,经过反应、浸出、浸出液两次净化和浓缩结晶制备硫酸锰,考察了反应时间、含SO_2尾气的流量及反应温度对Mn~(4+)转化率的影响.实验结果表明:在反应时间45 min、反应温度20～30 ℃、含SO_2尾气流量16 L/min的条件下,Mn~(4+)转化率达90%以上;尾气中SO_2利用率随尾气流量增加而降低;所得MnSO_4·H_2O产品质量达到GB1622-86<工业级硫酸锰标准>.     

重庆市道路交通空气监测现状及控制对策

分析重庆市道路交通空气质量自动监测站的各项参数监测数据的变化趋势,并对机动车尾气对大气环境的影响进行了分析与评估。同时结合一些先进的预防、控制和处理汽车尾气污染的方法,提出了一些意见和建议来防止机动车尾气污染进一步蔓延。     

北京大气中异戊二烯的季变化、日变化形式及影响因素研究

对2005年北京大气中异戊二烯进行了一年的观测分析。结果表明,异戊二烯体积分数年平均值为0.58×10^-9,月平均值为0.1×10^-9～1.8×10^-9,7月最高,1月最低。春、秋、冬三季,异戊二烯日变化形式呈三峰形,分别在14:00、18:00、02:00;18:00、02:00、08:00;02:00、10:00、16:00出现峰值;夏季异戊二烯体积分数日变化呈现白天高夜晚低且在14:00出现峰值。夏季异戊二烯源排放主要由生物排放控制,其日变化形式受温度、辐射影响大;春季和秋季异戊二烯源排放受汽车尾气和生物排放共同控制,其日变化形式受汽车尾气影响大,温度、辐射也有一定影响;冬季异戊二烯源排放主要由汽车尾气控制,其日变化形式主要受汽车尾气影响。不同季节北京大气中的异戊二烯体积分数日变化形式与PM_2.5浓度日变化形式大致相同。     

上海浦东国际机场飞机尾气排放对机场附近空气质量的影响

统计2012年10月和11月浦东机场飞机机型和航班架次，根据各类飞机起降的污染物排放设计工作参数，估算出2012年浦东机场飞机起降时排放的NO2、SO2、CO和HC的估算值。利用浦东新区13个空气监测子站二氧化氮和二氧化硫数据绘制等值线图。结果显示，机场所在的江镇点位和祝桥点位二氧化氮浓度变化受飞机影响很大，而飞机排放的二氧化硫对两个点位的影响可以忽略不计。建议采用改进飞机滑行路线、探讨征收飞机碳排放税等措施减少飞机尾气排放对空气质量的影响。     

应用CALINE4模式估算机动车排放污染物的浓度——以济南市主干道为例

随着经济的快速发展,机动车排气污染已成为我国城市空气污染的重要来源,而且在一定时段,机动车排气污染已成为空气污染最主要的污染源之一。以济南市经十路为例,采用实地调查的方法,得出各时段的车流量,选用大气环评助手EIAA中的CALINE4模式对机动车尾气中的主要污染物CO、NOx、THC的排放浓度进行估算,得出3种污染物CO、NOx、THC最大值均出现在7:00—8:00之间,最小值均出现在12:00-13:00之间,排放强度由大到小为:CO、THC、NOx。     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

小氮肥厂的三废及其治理

论述了小氮肥厂生产中废水、废气和废渣和产生及其废水，废气的治理方法与效果。介绍了利用废渣制砖和水泥的技术。     

集中排烟公路隧道入口段火灾下诱导风速研究

为研究集中排烟模式下公路隧道入口段发生火灾时的合理诱导风速,以某公路隧道为背景,运用火灾动力学模拟软件FDS对隧道人口段火灾时不同坡度、不同诱导风速的16组火灾工况进行模拟研究,通过对各工况下隧道内的温度场分布及烟气控制效果模拟结果的分析,得到了各工况下的合理诱导风速,研究结果可为公路隧道集中排烟系统关键设计参数提供参考.     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.