Enhanced debromination of 2,2′,4,4′-tetrabromodiphenyl ether (BDE-47) by zero-valent zinc with ascorbic acid

• Highly efficient debromination of BDE-47 was achieved in the ZVZ/AA system. • BDE-47 debromination by the ZVZ/AA can be applied to a wide range of pH. • AA inhibits the formation of (hydr)oxide and accelerates the corrosion of ZVZ. • Reduction mechanism of BDE-47 debromination by the ZVZ/AA system was proposed. A new technique of zero-valent zinc coupled with ascorbic acid (ZVZ/AA) was developed and applied to debrominate the 2,2′,4,4′-Tetrabromodiphenyl ether (BDE-47), which achieved high conversion and rapid debromination of BDE-47 to less- or non-toxic forms. The reaction conditions were optimized by the addition of 100 mg/L ZVZ particles and 3 mmol/L AA at original solution pH= 4.00 using the solvent of methanol/H₂O (v:v= 4:6), which could convert approximately 94% of 5 mg/L BDE-47 into lower-brominated diphenyl ethers within a 90 min at the ZVZ/AA system. The high debromination of BDE-47 was mainly attributed to the effect of AA that inhibits the formation of Zn(II)(hydr)oxide passivation layers and promotes the corrosion of ZVZ, which leads to increase the reactivity of ZVZ. Additionally, ion chromatography and gas chromatography mass spectrometry analyses revealed that bromine ion and lower-debromination diphenyl ethers formed during the reduction of BDE-47. Furthermore, based on the generation of the intermediates products, and its concentration changes over time, it was proposed that the dominant pathway for conversion of BDE-47 was sequential debromination and the final products were diphenyl ethers. These results suggested that the ZVZ/AA system has the potential for highly efficient debromination of BDE-47 from wastewater.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

Listing for change? Exploring the politics of relief lists in Bangladesh after Cyclone Sidr

Ideal notions of efficient aid are challenged continuously by realities on the ground in the wake of major disasters, such as dire needs, limited resources, and opportunism. This paper demonstrates how ‘relief lists’ can be productive entry points for a systematic inquiry into the pervasive politics of disaster assistance. Through an analysis of qualitative data collected during the five years after Cyclone Sidr struck Bangladesh on 15 November 2007, it examines how relief lists featured in both physical and phantom forms and then developed beyond their transparency-making aims, becoming elevated sites of struggle for post-disaster resources. Three list processes, selected to indicate the temporal, material, and spatial dynamics of relief encounters, are assessed in depth. Although recipients of cyclone relief appreciated its value, the paper argues that list politics also stimulated structures of vulnerability, including inequality. Gradually, relief, as governed after Sidr, also served to restore the differential vulnerability of the country's coastal poor.     

Metal concentrations in used engine oils: Relevance to site assessments of soils

Used engine oils contain metals, which upon entering soils may pose risks to human health or the environment. In this study, previously published concentrations of 23 metals in 213 used engine oil samples from the early 1970s to the mid-1990s are statistically evaluated. Neat (100%) used engine oils were found to contain relatively high concentrations of lead, calcium, and zinc, attributable to piston blow-by of leaded gasoline, calcium salt detergent additives, and zinc-bearing anti-corrosion/anti-oxidation additives, respectively. Wear metal concentrations were lower. The lead concentration in used engine oils in the U.S. declined between the 1970s and early 1990s, potentially providing a basis to constrain the “age” of used engine oil(s) in soils. The concentrations of 23 metals in used engine oils were compared to soil risk benchmarks in 15 representative jurisdictions in the U.S., Canada, Australia, and Europe. The maximum concentrations in neat (100%) used engine oil of eight metals – Be, Co, Fe, Mn, Ni, Se, Ag, and Ti – were lower than their collective minimum benchmarks in soils for the jurisdictions surveyed, indicating their concentrations in soils could not be reasonably expected to exceed any soil benchmarks. Nine metals (As, Ba, Cd, Cr, Cu, Pb, Sn, V and Zn), but particularly arsenic, cadmium, lead, tin, and zinc, were identified as potential contaminants of concern (PCOC) for soils from locations impacted with used engine oils, owing to their higher median concentrations (i.e., 2.5, 1.4, 1038, 5.0, and 922 mg/kg in oil, respectively) relative to most soil benchmarks. Site-specific benchmarks and metal concentrations at reasonable oil in soil concentrations require consideration when developing the suite of PCOC metal analytes for conducting site assessments of soils impacted by used engine oil.     

Study of the influence of melamine polyphosphate and aluminum hydroxide on the flame propagation and explosion overpressure of aluminum magnesium alloy dust

When aluminum magnesium alloy dust floats in the air, a certain ignition energy can easily cause an accidental explosion. To prevent and control the occurrence of accidental explosions and reduce the severity of accidents, it is necessary to carry out research on the explosion suppression of aluminum magnesium alloy dust. This paper uses a vertical glass tube experimental device and a 20 L spherical explosive experimental device to carry out experimental studies on the suppression of the flame propagation and explosion overpressure of aluminum magnesium alloy dust with melamine polyphosphate (MPP) and Al(OH)₃. With increasing MPP and Al(OH)₃ concentrations, the flame brightness darkened, the flame velocity and propagation distance gradually decreased, and P_max and (dp/dt)_max decreased significantly. When the amount of MPP added reached 60%, the flame propagation distance decreased to 188 mm, which is a decrease of 68%, and the explosion overpressure decreased to 0.014 MPa, effectively suppressing the explosion of aluminum magnesium alloy dust. The experimental results showed that MPP was more effective than Al(OH)₃ in inhibiting the flame propagation and explosion overpressure of the aluminum magnesium alloy dust. Finally, the inhibitory mechanisms of the MPP and Al(OH)₃ were further investigated. The MPP and Al(OH)₃ endothermic decomposition produced an inert gas, diluted the oxygen concentration and trapped active radicals to terminate the combustion chain reaction.     

我国区域空气污染治理效率及其影响机制——基于超效率SBM模型和门槛回归模型

随着人民对美好生活需求的日益增长,政府空气污染治理的效率问题日益得到重视。本文从地方政府空气污染治理效率及其影响因素的视角入手,以全国30个省份为研究对象,运用超效率SBM模型测算2003—2015年各省级区域的空气污染治理效率。在此基础上,运用门槛回归模型分析政府空气污染治理效率的影响机制。研究表明:①地区间空气污染治理效率差异性较为显著。中部、西部空气污染治理效率整体呈下降趋势。东部和东北地区空气污染治理效率则上升比较平稳。②政策规划、碳源、污染物排放和环境治理投入表现出双重门槛特征,其中碳源对空气污染治理效率影响显著,而以碳为首的能源消费结构则主要对中部和西部空气污染治理效率产生影响。落后地区政府应注重产业升级,财政上应对碳税等税目进行征收,产业上应鼓励企业创新,并对落后企业进行倒逼升级。     

A review of measurement methods for peracetic acid (PAA)

• Physical and chemical properties and application of peracetic acid solution. • Determination method of high concentration peracetic acid. • Determination method of residual peracetic acid (low concentration). Peroxyacetic acid has been widely used in food, medical, and synthetic chemical fields for the past several decades. Recently, peroxyacetic acid has gradually become an effective alternative disinfectant in wastewater disinfection and has strong redox capacity for removing micro-pollutants from drinking water. However, commercial peroxyacetic acid solutions are primarily multi-component mixtures of peroxyacetic acid, acetic acid, hydrogen peroxide, and water. During the process of water treatment, peroxyacetic acid and hydrogen peroxide (H₂O₂) often coexist, which limits further investigation on the properties of peroxyacetic acid. Therefore, analytical methods need to achieve a certain level of selectivity, particularly when peroxyacetic acid and hydrogen peroxide coexist. This review summarizes the measurement and detection methods of peroxyacetic acid, comparing the principle, adaptability, and relative merits of these methods.     

公路项目施工期环评要点分析

本文首先介绍公路项目施工期环评的现实意义,之后阐述公路项目施工期环评要点,以此强化公路项目施工期环评水平及其环保效益。     

土壤中7种重金属和砷测定的精密度控制指标研究

通过对浙江省近700组实际土壤样品进行分析,研究了土壤中铜、铅、锌、铬、镍、镉、砷、汞7种重金属和砷测定的精密度控制指标(实验室内相对偏差和实验室间相对偏差),并与行业标准分析方法和文献进行了比较,旨在为环境监测质量控制与质量保证工作提供参考。经统计分析,建议实验室内相对偏差控制指标如下:铜,≤15%;铅,≤15%;锌,≤15%;铬,≤15%;镍,≤15%;镉,≤20%;砷,≤15%;汞,≤50%。建议实验室间相对偏差控制指标如下:铜,≤25%;铅,≤25%;锌,≤20%;铬,≤20%;镍,≤25%;镉,≤35%;砷,≤25%;汞,≤55%。     

污染源普查后区域环境管理应用探讨

在第二次全国污染源普查的基础上,利用污染源普查期间配置的软硬件,开发市级区域环境污染源管理平台,进行污染源数据的年度更新,拓展污染源普查软件应用,实现环境管理及环境执法移动终端的应用。拓展二污普一张图的功能,利用移动客户端机动实时及地定位导航等为环境管理执法和环境突发事件应急处置提供技术支持。