膜法水处理技术及研究进展

综述了反渗透、微滤、超滤、纳滤、渗透蒸发、液膜等几种常见膜技术的应用现状及进展情况 ,主要对反渗透膜的原理、流程、存在的问题及开发和利用情况进行了介绍。简单概括了近年发展起来的双极膜等新膜分离技术的开发研究。展望了膜分离技术的前景     

隔油沉淀-预曝调节-接触氧化-气浮工艺处理屠宰加工废水

对屠宰加工过程中产生的中高浓度有机废水采用预曝调节-接触氧化-气浮工艺进行处理。当进水COD浓度为980~1200mg/L时,出水COD浓度可降至76.1~104mg/L,优于国家《肉类加工工业水污染物排放标准》(GB13457-92)二级标准,此工艺的抗冲击负荷能力较强,适应于间歇性生产和季节性生产的屠宰加工企业。     

城市垃圾污染防治对策探讨

从城市拉圾产生的机制入手，分析了城市垃圾污染产生的原因，并对目前所采取的主要处理方法人季简要评述，在此基础提出了实现城市垃圾最小量化，推动垃圾资源化产业、提高垃圾无害化处理水平，中化监督管理等几点城市垃圾污染防治的对策。     

皮革废水物化处理工艺整改的试验研究

在扬州某皮革厂原有的废水处理设施基础上，采用浓淡分流，药剂调整等方法。对其物化处理部分进行整改。结果表明，用Fe2SO4作混凝剂处理浓废水及用复合混凝剂处理淡废水，效果较好。处理后，可减少排放废水CODcr约1252t／a。处理成本从原来的4.03元／t降到1.30元／t。同时，降低了加药量的控制难度与加药频率，减轻了工人的劳动强度。     

清洁的胡椒基T醚生产工艺的研究I,5-丙基-1,3-苯并二氧杂茂的氯甲基化废水的处理

报道了胡椒基丁醚生产中５－丙基－１，３－苯并二氧杂茂的氯甲基化的废水处理，该废水经蒸馏可回收９４％的盐酸，此酸吸收氯化氢后浓度在３６％以上，可再用于氯甲基化反应。蒸馏残液经分油、Ｆｅｎｔｏｎ试剂处理和五次生炭柱吸附后ＣＯＤＣｒ等项指标均可国家二类污染物的一级排放标准。     

1000t/d含油废水旋流分离技术及设备研究

将实验室研制的 HL 型旋流器用压力容器式方式并联起来 ,建立 10 0 0 t/ d规模的示范装置 ,并进行试验。示范装置的试验结果表明 ,与工业测试比较 ,HL型旋流器并没有因为规模的放大而造成性能下降 ,它能取代石化行业目前采用的“一隔二浮”流程中的大部分装置 ,具有明显的经济效益和广阔的应用前景     

DOM-Flocculation: A suitable approach for separating free and DOM-bound herbicides?

Dissolved organic matter (DOM) in soil solution is considered to interact with herbicides enhancing their mobility and promoting subsequent leaching. Batch experiments were conducted to test if free and DOM-bound herbicides can be separated by a DOM-flocculation technique with Cu as a coagulant. DOM was extracted from the H and A horizons of two soils (Terric Histosol, Cumuli-Calcaric Cambisol) and from the O horizon of a forest soil (Humic Cambisol). DOM-solutions (100 mL) were fortified with the herbicides terbuthylazine and pendimethalin (100 μg active ingredient each) and equilibrated for 14 hours. After DOM-flocculation with Cu (addition of 0,5 mM CuCl₂) herbicide recovery was determined in the supernatant solutions and in the precipitate of Humic Cambisol-DOM, respectively. Recovery of the herbicides from pure water was 85–99% and was not influenced by the addition of Cu. At low pH (4,8–5,3) DOM-flocculation of different DOM-extracts was insufficient and varied in a range of 18 – 90%. Herbicide recovery from DOM-solutions decreased moderately for terbuthylazine (60–90%) and strongly for pendimethalin (5 – 30%). In general, the addition of Cu caused no further reduction of herbicide recovery from supernatant solutions, except for Humic Cambisol-DOM. The effects of Cu-addition were most evident for pendimethalin (strongly reduced concentration in the supernatant solutions) and were considered to be caused by a flocculation of DOM-bound moieties. Flocculation of Humic Cambisol-DOM increased from 18 – 24% at pH 5 to > 95% at pH 8. However, at this pH the formation of Cu(OH)₂ as a sorbing subcomponent of the flocculated matter lead to an overestimation of DOM-bound pendimethalin. Calculating this side effect 6% of pendimethalin added was DOM-bound. Only traces of terbuthylazine (< 1%) were found in the solid matter of flocculated Humic Cambisol-DOM. To sum up, the new approach to separate freely dissolved herbicides from DOM-bound moieties not fully corresponded to our expectations. DOM-flocculation was found to depend strongly on pH-environment influencing not only DOM-herbicide interactions but also the clear separation of DOM-bound herbicides from herbicides in solutions.     

Carbon nanotubes as sorbents in the analysis of pesticides

With increasing public concerns for agrochemicals and their potential movement in the ecosystem, very sensitive, selective and precise methods for the analysis of pesticides are needed. Because these substances are present usually at trace levels, the extraction and preconcentration steps are so far essential for their detection. Discoveries of novel nanomaterials with unique properties have significant impact on their use also in extraction techniques. This overview reports the recent application of carbon nanotubes in the analysis of pesticides. The largest numbers of reported applications of carbon nanotubes concern their role as a sorbent materials in solid-phase extraction and microextraction techniques.     

Improvement of an efficient separation method for chemicals in diesel exhaust particles: analysis for nitrophenols

GOAL, SCOPE, AND BACKGROUND: Diesel exhaust is believed to consist of thousands of organic constituents and is a major cause of urban pollution. We recently reported that a systematic separation procedure involving successive solvent extractions, followed by repeated column chromatography, resulted in the isolation of vasodilatory active nitrophenols. These findings indicated that the estimation of the amount of nitrophenols in the environment is important to evaluate their effect on human health. The isolation procedure, however, involved successive solvent extractions followed by tedious, repeated chromatography, resulting in poor fractionation and in a significant loss of accuracy and reliability. Therefore, it was crucial to develop an alternative, efficient, and reliable analytical method. Here, we describe a facile and efficient acid-base extraction procedure for the analysis of nitrophenols. MATERIALS AND METHODS: Diesel exhaust particles (DEP) were collected from the exhaust of a 4JB1-type engine (ISUZU Automobile Co., Tokyo, Japan). Gas chromatography-mass spectrometry (GC-MS) analysis was performed with a GCMS-QP2010 instrument (Shimadzu, Kyoto, Japan). RESULTS: A solution of DEP in 1-butanol was extracted with aqueous NaOH to afford a nitrophenol-rich oily extract. The resulting oil was methylated with trimethylsilyldiazomethane and subsequently subjected to GC-MS analysis, revealing that 4-nitrophenol, 3-methyl-4-nitrophenol, 2-methyl-4-nitrophenol, and 4-nitro-3-phenylphenol were present in significantly higher concentrations than those reported previously. DISCUSSION: Simple acid-base extraction followed by the direct analysis of the resulting extract by GC-MS gave only broad peaks of nitrophenols with a poor detection limit, while the GC-MS analysis of the sample pretreated with (trimethylsilyl)diazomethane gave satisfactorily clear chromatograms with sharp peaks and with a significantly lowered detection limit (0.5 ng/ml, approximately 100 times). CONCLUSION: The present method involving an acid-base extraction, in situ derivatization, and GC-MS analysis has shown to be a simple, efficient, and reliable method for the isolation and identification of the chemical substances in DEP.     

Toward separation at source: Evolution of Municipal Solid Waste management in China

Municipal Solid Waste (MSW) management in China has been transitioning from a mixed collection and treatment system to a separated collection and treatment system. The continuous rise of MSW treatment capacity and the optimization of technology structure provided basic facility support for China to promote MSW separation at source. China preferred a four-type separation system. Regulated recycling should be enhanced to improve the efficiency and sustainability of recycling industry. As food waste is the main composition of MSW in China, 20%–30% of the food waste diversion and land application could maximize the comprehensive environmental performance. Incineration is to be the pillar technology in MSW separated treatment system in China.