基于反赋权与MBCT-SR多维云模型算法岩爆预测研究

基于岩爆事故的模糊性与随机性特征,为解决在当前岩爆烈度等级预测研究中,通过正向云发生器经验式计算多维云模型特征值进而导致预测结果主观性较强的问题.本文选取应力比Ts=σθ/σt、岩石脆性指数B=σc/σt以及弹性应变储能指数Wet作为评价指标,结合机器学习理论,采用多维逆向MBCT-SR云发生器算法对岩爆等级进行预测,...     

炼油厂IGCC电站NOx排放控制技术比较与工程实践

针对IGCC电站烟气排放ρ（NO_x）不达标的问题,分别采用燃气轮机注氮脱硝和余热锅炉（余热蒸汽发生器,HRSG ）SCR脱硝技术降低烟气的NO_x排放量。介绍了两种技术的原理,比较了两种技术的脱硝效果、运行成本及技术特点。实际运行结果表明：安装了注氮设备的燃气轮机可以控制排气的ρ（NO_x）小于90 mg/m³,但每年的运行成本较高（达2 250万元）;在余热锅炉中安装SCR脱硝设备,性能测试数据符合设计要求,SCR出口ρ（NO_x）小于50 mg/m³,且每年的运行成本较低,仅为422万元。     

CLIGEN生成干旱半干旱地区降水相关参数的验证

选用黄河上中游地区无定河流域为中心的15个气象站1959~1999年的降水日值资料,对随机天气发生器CLIGEN在干旱半干旱地区再现降水的能力进行了验证。结果表明:CLIGEN模型较好地模拟了该区域的降水发生概率;很好地再现了年、月、日降水总量平均值,平均相对偏差分别为2.4%、2.4%和2.1%;CLIGEN再现了96.4%的日降水变率、95.9%的月降水变率和84.1%的年降水变率。对年降水变率估计稍差,表明CLIGEN在模拟降水变率方面还有改进的必要。从降水极值看,年降水最大值的平均相对偏差为11.1%,偏差最大的是干旱区的临河站（39.1%）;年降水最小值的平均相对偏差为20.5%,偏差最大的是临河站（-30.7%）;月最大降水量除两站稍低外,其它站平均偏高20.2%;日降水最大值除临河站偏低3.4%外,其余各站平均偏高43.2%。总体上讲,CLIGEN在干旱地区的模拟能力比在半干旱区稍差。鉴于CLI-GEN模拟的极大值绝大部分都偏高,因此利用CLIGEN模型生成的降水资料运行径流和土壤侵蚀模型有高估径流量和土壤侵蚀量的可能,需要进一步利用自计雨量计的资料对CLIGEN生成次降水的参数进行验证,以确保径流和土壤侵蚀预测的精度。     

用于有界波模拟器的紧凑型纳秒脉冲源

随着电磁武器的发展,核电磁脉冲及其工程防护技术受到各国的普遍关注。为模拟电磁脉冲环境,研制了一台紧凑型纳秒脉冲源,与有界波模拟器配合可产生的双指数波形前沿~1.6ns,脉宽42ns,幅值可达60kV。本文介绍了脉冲源的设计与调试结果。     

Effect of high-voltage direct current link on small signal stability of a power system with different penetration level of doubly fed induction generator and direct drive synchronous generator based wind farms

High penetration level of wind power has significant impact on the dynamic performance of power system. Power system with existing high-voltage direct current (HVDC) link may influence the stability of power system at high penetration level of wind power. This article investigates the stability issues of power system with existing HVDC link for different penetration level of doubly fed induction generator (DFIG) and direct drive synchronous generator (DDSG) based wind farms. The small signal stability analysis shows that power system with HVDC link has improved the stability of the power system for increased penetration of DFIG- and DDSG-based wind farms.     

工业固体废物产生者连带责任辨析及其适用

一直以来，固体废物非法转移和倾倒等环境违法行为是固体废物管理实践中的首要突出问题。究其原因，根本在于法律对于固体废物产生者的义务和责任只局限于自身，在实践中产生者并不关注固体废物转移后的利用处置状况。新修订的《中华人民共和国固体废物污染环境防治法》（以下简称《固废法》）确立了工业固体废物产生者连带责任制度，力图从源头减少或避免固体废物非法转移和倾倒事件，倒逼固体废物产生者采取有效措施治理固体废物污染。笔者从固体废物产生者的双重身份入手，深入辨析其中的权利义务关系，阐释产生者连带责任的法律基础和根本原理。从《固废法》关于连带责任关系的法律规定出发，进一步解析产生者义务和受托者义务，并具体分析了连带责任的法律适用。     

某350MW汽轮发电机转子不稳定高阻接地故障查找方法及原因分析

介绍了某电厂350MW汽轮发电机转子绕组不稳定高阻多点接地故障的查找方法，接地故障的原因分析，为保证修复质量，除了按预试规程要求进行试验外，结合现场实际提出了“测量转子两极阻抗电压”对比的方法。     

Development of a field well head safety system for use with radiation generating devices

This paper discusses the design, testing and application of a new interlock system for field use with neutron generating bore hole probes at the Idaho National Engineering and Environmental Laboratory. Such probes produce 14 MeV neutrons at a yield up to 3×10⁸ neutrons/s, and present an ionizing radiation hazard to personnel particularly when operated in an unshielded configuration. This interlock system prevents personnel from being exposed to the relatively high radiation fields caused by an unsafe condition when an operating neutron generator probe is withdrawn from a well in the ground. An electromechanical interlock prototype system has been designed, built and tested, and has been found to be effective at preventing this event. The design is simple, is effective in mitigating the hazard, and can be installed in minutes. The system could be modified to interlock radiation-generating devices other than neutron generators that are used in similar environments.     

气浮中离子气团的应用

文章简介了离子气团产生的原理,离子气流发生器的工作原理及离子气团在水处理技术气浮中的应用.