Sustainable three‐well pumping strategy for efficient detection monitoring near waste impoundments

Efficient monitoring systems addressing the difficulty of detecting narrow contaminant plumes originating from unknown point sources are needed for modern landfills. A low‐discharge extraction and accompanying injection wells could potentially address this problem. This hypothetical computer‐modeling study involved a three‐well detection system consisting of one extraction and two injection wells at a rectangular landfill in a shallow, unconfined aquifer. The extraction and injection wells were located near the landfill's downgradient and cross‐gradient corners, respectively. Each injection well pumped at half the rate of the extraction well. A minimum pumping rate of 1.1 cubic meters per day was determined for the three‐well system; at this rate, all contaminant plumes originating within the landfill's footprint entered the extraction well prior to reaching a downgradient property boundary. In comparison, five passive (not pumped) wells detected all contaminant releases from the landfill. Results of this study suggest that a low‐discharge extraction well with accompanying injection wells may be an effective contaminant detection strategy at some waste impoundments.     

满足国六排放的缸内直喷汽油车污染物排放特性试验研究

以满足国六排放的某缸内直喷轻型汽油车为研究对象,试验研究了该车国六Ⅰ型测试循环(WLTC循环)排放的CO、THC、NOx和固态颗粒数量,以及包含挥发性/半挥发性组分的颗粒物数量和粒径分布特性.结果表明:WLTC循环工况覆盖范围广、车速高、加速度大的特点导致污染物排放增加;车辆冷机起动、暖机过程、瞬态过渡工况和高速大负荷工况对车辆的污染物排放影响较大,研发合理的车辆起动、催化剂起燃和暖机热管理策略、提高发动机瞬态过渡工况响应性是控制排放的重点;包含挥发性/半挥发性组分的颗粒物数量排放呈单峰分布,在15 nm附近达到峰值.     

油田高压注汽盐析及预防研究

本文分析研究了油田注汽系统盐析现象及其成因和危害,并根据盐析成因探索了预防注汽盐析方法以减少甚至消除其危害。通过研究确定,采用高压旋流饱和蒸发与低压闪蒸和多效蒸集成技术是预防注汽系统盐析并减少甚至消除盐析及其造成的危害较为有效的方法。     

Variation of reservoir fluid property during the high pressure air injection process

This research aimed at determining the variation of reservoir fluid property during the high-pressure air injection process. For this purpose, the forward multiple contact experiment was employed by pressure–volume–temperature (PVT) system to investigate the physical property variation of the crude oil and the complex oxidation reactions. The results show: under the relative low temperature and pressure condition, instead of carbon dioxide, carbon monoxide dominates the products in the air phase. The gas/oil ratio and volume ratio increased due to the generated gas while the viscosity and density achieved a descending trend. The colloid and bitumen in the oil phase reduced by half but the amount of wax achieved a small increase. The low-temperature oxidation and pyrolysis reactions caused the fluctuated change of the different compounds. The amount of light compounds decreased at the beginning and then increased while that of heavy compounds showed the opposite trend. But at last, due to the H/C ratio, the light compounds increased to more than their initial value.     

氨法脱硫副产物亚硫酸铵的塔外氧化

根据氨法脱硫反应机理,提出了将脱硫生成的亚硫酸铵溶液排放到吸收塔外进行氧化的方法,一方面可以减少脱硫塔的注氨量,有效控制吸收塔出口烟气中的逸氨及硫酸铵气溶胶,避免二次污染;另一方面,可以提高吸收塔内亚硫酸铵浓度,保持较高的脱硫率.塔外氧化对于氨法脱硫是一种比较合理的氧化方法.     

脱硫系统GGH吹灰器高压水喷嘴改进

GGH堵塞是脱硫系统运行常见问题之一,介绍了通过扩大吹灰器高压水喷嘴口径,增加喷嘴射流流量,提高对脱硫系统GGH清洗效果的途径,并实现脱硫系统不开烟气旁路挡板进行GGH波纹板高压清洗的目的。     

流动注射对氨基二甲基苯胺光度法测定水体中的硫化物

为了克服分光光度法反应时间难以控制引起的方法精密度、准确度不高的弱点，采用流动注射技术与分光光度法相结合的方法，用微机化流动注射分析仪准确控制时间，优化了实验条件，建立了测定痕量硫化物的流动注射分光光度方法。分析速度每小时80次，擎一质量浓度在0．02～0．8mg／L与吸光度A具有良好的线性关系。方法直接测定海水和鱼塘水中的硫化物获得满意的结果，回收率分别为100．28％和97．13％。     

大体积进样技术结合同位素稀释法测定地表水中多环芳烃的研究

采用C18固相萃取柱预处理水样,由于固相萃取柱的选择吸附性,净化了样品的基质;同液-液萃取相比,固相萃取柱和硅胶小柱的双重净化,更适合大体积进样。萘、苊、菲、屈艹的氘代化合物作为同位素稀释剂,由于待测分析物与同位素稀释剂物理化学的相似性,其在固相萃取柱的保留行为和色谱运行行为都有基本一致性。同一般内标法相比,同位素稀释法具有较高的回收率。大体积进样由于进样绝对量的增加,降低了检出限。方法检出限0.05～0.1ng/L,回收率范围90%～110%。     

流动注射分析仪在测定水体总氮中的实验研究

总氮是衡量水质富营养化的重要指标。用传统方法分析需经过高压消解,温度和时间难以控制,且手工操作复杂、费时,误差大,影响监测结果。本文用流动注射法,以QuickChem 8000流动注射仪为平台,通过大量的精密性、准确性和实样比对实验来研究其在水质总氮测定中的应用,再用数理统计的方法（F检验、t检验）从理论上验证该方法的可行性。     

流动注射分析法测定底质中总磷的研究

在一定的温度下,用硫酸和高氯酸进行消解,使不溶性磷酸盐和有机磷转化为正磷酸盐进入溶液.酸性条件下,待测液在酒石酸锑钾的催化下,与钼酸铵反应生成磷钼酸化合物.该化合物与抗坏血酸反应生成蓝色络合物.该络合物在880 nm比色.实验结果表明,底质中的总磷的RSD＜ 2％,回收率91％～103％,精密度和准确度满足实验要求.因此,流动注射分析法适用于底质中总磷的监测.