CuSnZr三元催化剂应用于NTP强化催化脱硫过程的特性

为高效地在低温下处理大量低浓度电解铝烟气, 采用浸渍法制备了Sn Zr型金属氧化物并添加Cu作为助剂的催化剂, 并首次测试了它在低温等离子体(NTP)技术上的脱硫效果, 结果表明负载了20wt% Cu老化温度为40℃的催化剂表现出最佳的脱硫性能.并对强化之后的催化剂进行了表征, 与新鲜的催化剂对比, X射线衍射分析(XRD)结果表明放电对催化剂晶型基本不产生影响; 扫描电子显微镜(SEM), 氮吸附和脱吸(BET)表明放电会使催化剂的吸附脱附能力与孔道结构有较大提升; X射线光电子光谱(XPS)也表明放电会使催化剂表面元素价态变化, 从而使其氧化还原性能改变, 反应路径发生偏向; 催化剂性能理论计算表明铜含量的上升会导致催化剂能带结构改变, 更好利用于激发气体.     

Semi-closed synthesis of nitrogen and oxygen Co-doped mesoporous carbon for selective aqueous oxidation

Heteroatom-doped meso/micro-porous carbon materials are conventionally produced by harsh carbonization under an inert atmosphere involving specific precursors, hard/soft templates, and heteroatom-containing agents. Herein, we report a facile synthesis of N and O co-doped meso/micro-porous carbon (NOMC) by template-free carbonization of a small-molecule precursor in a semi-closed system. The semi-closed carbonizaiton process yields hydrophilic NOMCs with large surface area in a high yield. The porous structure as well as the elemental composition of NOMCs can be modulated by changing the holding time at a particular temperature. NOMCs as metal-free heterogeneous catalysts can selectively oxidize benzyl alcohol and its derivatives into aldehydes/ketones with>85％conversion in aqueous solution, which is much higher than that of the control sample obtained in tube furnace (21％conversion), mainly due to their high N content, high percentage of pyridinic N, and large surface area. The presence of O-containing moieties also helps to improve the hydrophilicity and dispersion ability of catalysts and thus facilitates the mass transfer process during aqueous oxidation. The NOMC catalysts also dispayed excellent activity for a wide range of substrates with a selectivity of>99％.     

烟气中SO2/NOx同时吸收催化脱除的研究

根据同时脱硫脱硝的要求,对以ＣＵＯ为主要活性组分催化剂的制备和反应过程进行研究,活性测试的结果表明,催化剂的最佳活化温度和活化时间分别为４５０℃和２ｈ。当反应温度为４００℃,空间速度为２×１０＾４ｈ＾－１以及ＣｕＳＯ４／ＣｕＯ摩尔比和Ｃｕ／Ｓ分别保持在１．４６和０．８３以上时,ＳＯ２和ＮＯｘ的脱除率可达９０％以上。     

净化含氮有机污染物的催化剂及工艺

介绍了两种催化剂PCN-1,PCN-2型对含氮有机物如N,N-二甲基甲酰胺(DMF)、正丁胺、环己胺、苯胺、硝基苯等深度氧化的活性及控NO_x能力。实验结果表明,由PCN-1、PCN构成的双催化剂处理DMF或DMF与甲苯、DMF与甲乙酮的混合蒸气,其氧化活性和控NO_x能力比单一催化剂为好。在240—300℃温度范围即可完全氧化,控NO_x率达98％以上,净化气无色无臭。本工艺可用于PU合成革生产线烘道排气的净化处理。     

预磁化强化ZnO@Fe3O4活化PMS降解AO7

为了研究预磁化对ZnO@Fe_3O_4活化过一硫酸盐(PMS)去除水中酸性橙7(AO7)性能的影响,考察了预磁化强度、ZnO@Fe_3O_4投量、PMS投量及初始pH对Mag-ZnO@Fe_3O_4/PMS体系降解AO7效果的影响.结果表明,当预磁化强度由0 T逐渐增大至2 T时,催化剂去除AO7的表观速率常数由0.0463 min~(-1)逐渐增大至0.1832 min~(-1),反应速率提高倍数达到1.4～4.0倍; Mag-ZnO@Fe_3O_4和PMS投量的增加对AO7的去除率均有提升效果,在最优条件下反应20 min后AO7的去除率达92%;体系初始pH对AO7降解有显著影响, pH为6～8条件下有利于Mag-ZnO@Fe_3O_4催化PMS氧化反应的进行.通过投加不同种类的猝灭剂,证实了AO7的降解主要是各种自由基共同作用的结果.经过预磁化处理后的催化剂产生感应磁场,从而影响了反应体系中自由基的复合概率,使得污染物被自由基氧化的速率提高.     

Bi/Fe_3O_4催化NaBH_4还原水中对硝基苯酚

以磁性Fe_3O_4为载体负载Bi(NO_3)_3,再用NaBH_4还原Bi~(3+)制备了Bi/Fe_3O_4催化剂。采用XRD和紫外-可见光谱对催化剂进行表征。考察了Bi负载量、NaBH_4加入量和Bi/Fe_3O_4加入量对Bi/Fe_3O_4催化NaBH_4还原对硝基苯酚(4-NP)效果的影响。表征结果显示:当催化剂中Bi含量较少时,Bi分散良好;当Bi含量较多时,会形成纳米颗粒。实验结果表明:当反应温度为25℃,初始4-NP浓度为4.0 mmol/L时,在Bi负载量为5%(w)、Bi/Fe_3O_4催化剂加入量为500 mg/L,NaBH_4加入量为6.0 g/L的条件下,反应速率常数为0.581 min~(-1),4-NP的去除率为99.7%;Bi/Fe_3O_4催化剂稳定性好,重复使用15次后,活性基本不变。     

Bi2O3-TiO2复合光催化剂协同处理铬-邻苯二甲酸酯复合污染

以硝酸铋和钛酸丁酯为前驱体,采用水热法制备了Bi_2O_3-TiO_2复合半导体材料,并利用X射线衍射(XRD)、紫外-可见吸收光谱(UVVis)、能谱分析(EDS)、X射线光电子能谱(XPS)等手段对复合材料的结构进行了表征.同时,考察了Bi_2O_3-TiO_2复合材料对重金属Cr(Ⅵ)和难降解邻苯二甲酸二丁酯(DBP)复合污染的处理性能,并探讨了复合催化剂协同处理复合污染的作用机制.结果表明:该复合催化剂在可见光下能同时降低重金属Cr(Ⅵ)和有机物DBP的浓度,抑制电子和空穴复合,表现出比对单一Cr(Ⅵ)及DBP污染物更高的处理效率.当Bi_2O_3含量为4%时,复合催化剂表现出最佳的光催化活性.     

SO2和H2O对Mn-Ce/TiO2催化剂低温SCR活性的影响

采用溶胶凝胶法制备Mn-Ce/TiO_2低温SCR催化剂并考察其活性,研究了SO_2和H_2O对Mn-Ce/TiO_2低温脱硝催化剂的影响,并运用XRD、BET、SEM和FT-IR对中毒前后的催化剂进行表征。结果表明,催化剂在无SO_2和H_2O条件下具有良好的脱硝性能,在140℃时NO_x去除率达到84%。但若向模拟烟气中加入SO_2和H_2O,则随其体积分数增大对催化剂活性产生明显抑制作用。当H_2O的体积分数为5%、SO_2为700×10-6时,反应4 h后,NO_x去除率降为53%。H_2O对催化剂的抑制作用随H_2O的除去而消除,H_2O主要通过与NO_x的竞争吸附来抑制催化剂的活性。低浓度的SO_2对催化剂活性影响较小,SO_2体积分数为100×10~(-6)时,稳定后NO_x去除率仍能维持在80%以上,但较高体积分数的SO_2引起的催化剂失活不可自行恢复。SO_2毒化作用主要是引起了硫酸铵盐覆盖催化剂的表面活性位,以及造成活性组分MnO_x的晶化,并破坏了MnO_x与TiO_2间的强相互作用。H_2O和SO_2共同存在时,H_2O可以弱化SO_2对催化剂的毒化作用,主要因为H_2O与SO_2的竞争吸附作用而使SO_2对催化剂活性的影响减弱。     

Two-step fast microwave-assisted pyrolysis of biomass for bio-oil production using microwave absorbent and HZSM-5 catalyst

A novel technology of two-step fast microwave-assisted pyrolysis(f MAP) of corn stover for bio-oil production was investigated in the presence of microwave absorbent(Si C) and HZSM-5catalyst. Effects of f MAP temperature and catalyst-to-biomass ratio on bio-oil yield and chemical components were examined. The results showed that this technology, employing microwave, microwave absorbent and HZSM-5 catalyst, was effective and promising for biomass fast pyrolysis. The f MAP temperature of 500°C was considered the optimum condition for maximum yield and best quality of bio-oil. Besides, the bio-oil yield decreased linearly and the chemical components in bio-oil were improved sequentially with the increase of catalyst-to-biomass ratio from 1:100 to 1:20. The elemental compositions of bio-char were also determined. Additionally, compared to one-step f MAP process, two-step f MAP could promote the bio-oil quality with a smaller catalyst-to-biomass ratio.     

不同SAPO分子筛负载MnOx催化剂的低温NH3-SCR性能研究

以磷酸硅铝分子筛SAPO-5、SAPO~(-1)1和SAPO-34为载体,采用乙醇分散法制备了用于低温氨选择性还原(NH_3-SCR)NO_x的分子筛负载MnO_x催化剂.活性测试结果显示,3种分子筛催化剂均展现出优良的NH_3-SCR活性,但三者在低温区间的SCR活性存在较明显差异,其SCR活性顺序如下:MnO_x/SAPO-34MnO_x/SAPO-5MnO_x/SAPO~(-1)1.借助XRD、N2吸附-脱附、XPS、H2-TPR、NH_3-TPD、NH_3FT-IR等技术对催化剂的表面活性物种及表面酸性等进行表征分析,结果表明,MnO_x主要以无定型状态分散于载体上,负载后载体的比表面积和孔体积均有所下降.XPS和H2-TPR分析证实,不同分子筛载体上MnO_x的表面浓度与氧化态明显不同.NH_3-TPD和NH_3FT-IR分析揭示了催化剂表面均存在Bronsted酸位和Lewis酸位,其中,Lewis酸性位对低温SCR反应起着关键作用.研究表明,催化剂的催化性能会因载体不同而存在差异,高Mn4+表面浓度和丰富的Lewis酸性位对催化剂在低温区间实现优良的催化活性尤为重要.