改性沸石去除工业乳化废水中COD的研究

采用10%HCl浸渍处理后改性沸石处理工业乳化废水。试验结果表明,改性沸石处理工业乳化废水的优化条件为：最佳粒径0.074 mm～0.10 mm,改性沸石与乳化废水的质量比4：100,搅拌时间40 min,静置时间60 min;该优化条件下,改性沸石对工业乳化废水的COD去除率达83%～85%,效果优于聚铁。     

Adsorption characteristics of humic acid-immobilized amine modified polyacrylamide/bentonite composite for cationic dyes in aqueous solutions

Humic acid-immobilized amine modified polyacrylamide/bentonite composite (HA-Am-PAA-B) was prepared and used as an adsorbent for the adsorption of cationic dyes (Malachite Green (MG), Methylene Blue (MB) and Crystal Violet (CV)) from aqueous solutions. The polyacrylamide/bentonite composite (PAA-B) was prepared by intercalative polymerization of acrylamide with Nabentonite in the presence of N,N0-methylenebisacrylamide as a crosslinking agent and hexamethylenediammine as propagater. PAA-B was subsequently treated with ethylenediammine to increase its loading capacity for HA. The surface characterizations of the adsorbent were investigated. The adsorbent behaved like a cation exchanger and more than 99.0% removal of dyes was detected at pH range 6.0–8.0. The capacity of HA-Am-PAA-B was found to decrease in the following order: MG > MB > CV. The kinetic and isotherm data were interpreted by pseudo-second order rate equation and Freundlich isotherm model, respectively. Experiments were carried out using binary solute systems to assess the competitive adsorption phenomenon. The experimental isotherm data for each binary solute combination of MG, MB and CV were analyzed using Sheindrof-Rebhun-Sheintuch (SRS) (multicomponent Freundlich type) equation.     

Photocatalytic performance of TiO2 catalysts modified by H3PW12O40, ZrO2 and CeO2

The binary composite photo-catalysts CeO2/TiO2, ZrO2/TiO2 and the ternary composite photo-catalysts H3PW12O40-CeO2/TiO2,H2PW12O40-ZrO2/TiO2 were prepared by sol-gel method. The catalysts were characterized by thermogravimetric-differential thermal analysis (TG-DTA), scanning electron microscopy (SEM) and X-ray diffraction (XRD). The photocatalyfic elimination of methanol was used as model reaction to evaluate the photocatalytic activity of the composite catalysts under ultraviolet light irradiation. The effects of doped content, activation temperature, time, initial concentration of methanol and gas flow rate on the catalytic activity were investigated. The results showed that after doping a certain amount of CeO2 and ZrO2, crystaniTation process of TiO2 was restrained, particles of catalysts are smaller and more uniform. Doping ZrO2 not only significantly improved the catalytic activity, but also increased thermal stability. Doping H3PW12O40 also enhanced the catalytic activity. The catalytic activities of binary and ternary composite photocatalysts were significantly higher than tin-doped TiO2. The dynamics law of photocatalytic reaction over the binary CeO2/TiO2 and ZrO2/TiO2 catalysts has been studied. The activation energy 15.627 and 15.631 kJ/mol and pre-exponential factors 0.5176 and 0.9899 s-1 over each corresponding catalyst were obtained. This reaction accords to the first order dynamics law.     

Chitosan and chemically modified chitosan beads for acid dyes sorption

The capabilities of chitosan and chitosan-EGDE (ethylene glycol diglycidyl ether) beads for removing Acid Red 37 (AR 37) and Acid Blue 25 (AB 25) from aqueous solution were examined. Chitosan beads were cross-linked with EGDE to enhance its chemical resistance and mechanical strength. Experiments were performed as a function of pH, agitation period and concentration of AR 37 and AB 25. It was shown that the adsorption capacities of chitosan were comparatively higher than chitosan-EGDE for both acid dyes. This is mainly because cross-linking using EGDE reduces the major adsorption sites -NH3+ on chitosan. Langmuir isotherm model showed best conformity compared to Freundlich and BET. The kinetic experimental data agreed very well to the pseudo second-order kinetic model. The desorption study revealed that after three cycles of adsorption and desorption by NaOH and HCl, both adsorbents retained their promising adsorption abilities. FT-IR analysis proved that the adsorption of acid dyes onto chitosan-based adsorbents was a physical adsorption. Results also showed that chitosan and chitosan-EGDE beads were favourable adsorbers and could be employed as low-cost alternatives for the removal of acid dyes in wastewater treatment.     

改性锯末吸附含Cr（Ⅵ）废水的实验研究

初步探讨了以改性后的锯末作为吸附剂去除废水中的Cr（Ⅵ）,实验表明改性锯末对于不同浓度的含Cr（Ⅵ）废水都具有较高的去除率。同时通过实验研究了pH值、吸附时间、吸附剂量、初始浓度等因素对吸附去除率的影响。     

天然菱铁矿改性及强化除砷研究

我国高砷地下水分布广泛,经济、高效地饮用水除砷技术受到广泛关注.静态批实验采用资源丰富、价格便宜的天然菱铁矿为主要原材料,考虑灼烧温度、时间及添加黏合剂等因素确定最优改性条件使除砷效果达到最佳.结果表明,在加铝量为10 mg.g-1、350℃下恒温灼烧90 min后造粒达到强度要求并除砷效果较优.25℃、固液比为0.5 g∶50 mL、As(Ⅲ)和As(Ⅴ)初始浓度为5 mg.L-1时,吸附后溶液中残留As浓度均<10μg.L-1.静态吸附批实验结果表明,25℃时,接触反应时间为12 h可达到吸附平衡,吸附过程较好地符合Lagergren假二级吸附速率方程;最优改性天然菱铁矿对砷的吸附规律可用Langmuir和Freundlich等温吸附模型很好地描述,As(Ⅲ)、As(Ⅴ)饱和吸附容量分别可以达到1 039、1 026μg.g-1.结合XRD、SEM等研究方法和比表面及孔结构分析初步探讨天然菱铁矿改性以及除砷的主要机制.分析表明,改性后天然菱铁矿比表面积大幅度增大,孔径减小,且在表面活化生成一层圆球状的含Fe(Ⅱ)和Fe(Ⅲ)的化合物.改性天然菱铁矿是一种值得进一步研究并实际应用的除砷材料.     

改性纳米碳管的理化性质、毒性及风险研究进展

随着纳米材料的广泛应用,在生产加工过程中,各种改性后的纳米碳管(CNTs)进入环境。充分认识改性后CNTs的理化性质是对其进行客观风险评价的重要前提。主要分析了几种常用方法改性后的CNTs的悬浮、吸附特征及其理化性质差异,综述了目前CNTs毒理学实验的研究进展,评价了其潜在风险,并提出了今后研究的方向。     

活性炭纤维的改性及对Cu~(2+)吸附性能影响的研究

采用硝酸、磷酸、磷酸二氢铵和硝酸铜水溶液对聚丙烯腈基活性炭纤维(PAN-ACF)进行浸渍改性,制备了4种改性活性炭纤维(ACF1-ACF4)。测定了改性活性炭纤维表面含氧酸性官能团、零电荷点、比表面积和孔容,评价了改性纤维对铜离子的吸附性能。结果表明改性后活性炭纤维表面含氧酸性官能团明显增加,其零电荷点相应降低,比表面积和微孔孔容增大。改性活性炭纤维对Cu2+的吸附容量显著提高,其中ACF2吸附性能最佳,其吸附容量从改性前的4.80 mg/g增加到17.32 mg/g,提高了3.6倍。     

改性膨润土的制备及其对Cr~(6+)的吸附研究

探讨了膨润土提纯土、有机改性土及锰化改性土在静态吸附条件下吸附Cr6+的最佳条件。同时进行了等温吸附研究,结果表明Freundlich吸附等温线模式能很好地描述改性膨润土对Cr6+的吸附。最后进行了改性膨润土吸附Cr6+的动力学研究,发现改性膨润土对Cr6+具有良好的吸附性能,动力学数据满足准二级动力学方程。     

改性桑枝粉对水中Cu(Ⅱ)的吸附及动力学

旨在为废弃桑枝的综合利用开辟新途径,以桑枝粉为原料,氢氧化钠为改性剂,对桑枝粉进行改性制备吸附剂,吸附去除水中Cu(Ⅱ).考察了改性桑枝粉用量、pH和吸附时间等因素对Cu(Ⅱ)的吸附去除率的影响,测定了吸附等温线,探讨了吸附性能,对等温吸附规律和吸附动力学进行了数学模拟.结果表明,改性桑枝粉用量、pH和吸附时间对Cu(...