废旧硬质聚氨酯泡沫塑料的木质素改性及再生

采用含有二乙二醇(DEG)和乙醇胺(ETA)的双组分解交联剂降解废旧硬质聚氨酯泡沫塑料(PU硬泡),并利用降解得到的低聚物多元醇与木质素复合制备出性能增强的再生PU硬泡。通过对制备的再生PU硬泡的红外光谱、密度、吸水率、抗压强度、热稳定性、导热系数、热重曲线等进行分析测试,考察m(DEG)∶m(ETA)对再生PU硬泡性能的影响。实验结果表明:m(DEG)∶m(ETA)=1∶3时废旧PU硬泡的降解效果最好;木质素加入量为2.0%(w)时再生PU硬泡的密度低、抗压强度高、保温性能良好,达到国家标准《建筑绝热用硬质聚氨酯泡沫塑料》(GB/T 21558—2008)的品质要求。     

北京市典型废弃物焚烧源2010—2017年二NFDA1英排放特征和减排效果分析

分析2010—2017年北京市三类典型废弃物焚烧源的废气二NFDA1英排放监测数据,计算排放因子和排放量,评估减排政策成效,并分析不同排放源达标排放时同类物分布特征异同和变化规律,探讨影响排放的重要因素。结果表明: 5家焚烧源平均排放浓度为 0.008～0.069 ng/m³(以TEQ计,下同),废气二NFDA1英排放因子为 0.027～1.7 μg/t,2016年向空气中排放的二NFDA1英量为 0.002 5～0.058 g；生活垃圾、危险废物和医疗废物焚烧源的低、高氯代同类物质量分数比的平均值分别为接近于 0.5、大于0.5和小于0.5,危险废物焚烧源的 ∑PCDFs、∑PCDDs质量分数比的平均值大于2； 123478-HxCDF和123678-HxCDF质量浓度接近且线性相关,具有相近的生成机理和去除效率； I-TEQ变化趋势与∑PCDFs质量分数的变化趋势基本一致,活性炭喷射和布袋除尘的去除效率是影响二NFDA1英排放的重要因素之一；危险废物焚烧源HWI1随运行时间增加排放浓度增加,而及时更换烟道管壁有助于消除“记忆效应”的不良影响。     

Structural equation model analysis for the evaluation of overall driving performance: A driving simulator study focusing on driver distraction

Objective: The present research relies on 2 main objectives. The first is to investigate whether latent model analysis through a structural equation model can be implemented on driving simulator data in order to define an unobserved driving performance variable. Subsequently, the second objective is to investigate and quantify the effect of several risk factors including distraction sources, driver characteristics, and road and traffic environment on the overall driving performance and not in independent driving performance measures.

Methods: For the scope of the present research, 95 participants from all age groups were asked to drive under different types of distraction (conversation with passenger, cell phone use) in urban and rural road environments with low and high traffic volume in a driving simulator experiment. Then, in the framework of the statistical analysis, a correlation table is presented investigating any of a broad class of statistical relationships between driving simulator measures and a structural equation model is developed in which overall driving performance is estimated as a latent variable based on several individual driving simulator measures.

Results: Results confirm the suitability of the structural equation model and indicate that the selection of the specific performance measures that define overall performance should be guided by a rule of representativeness between the selected variables. Moreover, results indicate that conversation with the passenger was not found to have a statistically significant effect, indicating that drivers do not change their performance while conversing with a passenger compared to undistracted driving. On the other hand, results support the hypothesis that cell phone use has a negative effect on driving performance. Furthermore, regarding driver characteristics, age, gender, and experience all have a significant effect on driving performance, indicating that driver-related characteristics play the most crucial role in overall driving performance.

Conclusions: The findings of this study allow a new approach to the investigation of driving behavior in driving simulator experiments and in general. By the successful implementation of the structural equation model, driving behavior can be assessed in terms of overall performance and not through individual performance measures, which allows an important scientific step forward from piecemeal analyses to a sound combined analysis of the interrelationship between several risk factors and overall driving performance.     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

不同好氧预处理方式对餐厨垃圾产甲烷的影响

为了研究不同好氧预处理方式对餐厨垃圾厌氧消化产甲烷的影响,通过建立3个模拟厌氧生物反应器,研究了传统厌氧生物反应器C1、上层好氧预处理-厌氧生物反应器C2和底部好氧预处理-厌氧生物反应器C3 3种不同操作条件下的产甲烷过程.结果表明,挥发性有机酸的累积使C1始终处于产甲烷滞后阶段;而C2、C3的好氧预处理通过加快易水解酸化组分和过量挥发性有机酸的好氧降解,有效缓解了酸性抑制,产甲烷滞后时间明显缩短至10 d内.第32天C2停止上层曝气后,在27 d内甲烷浓度达到了50％以上,同时,产甲烷速率迅速上升,并在第81天可达到峰值773 mL/(kg·d).C3在第11天停止底部曝气后,虽然经过22 d的时间甲烷浓度即上升至50％,但之后产甲烷速率经历回落阶段后再次逐渐上升,在实验结束时仅达到517 mL/(kg·d).上层曝气的好氧预处理方式所需曝气时间相对较长,但其产甲烷启动快,与底部曝气相比,其后期的甲烷化过程更稳定并可达到较高的产甲烷速率.     

酸碱度对生活垃圾焚烧厂沥滤液蒸发处理效果的影响

采用蒸发法处理城市生活垃圾焚烧厂垃圾沥滤液,着重考察了不同沥滤液初始pH值对蒸发去除COD和氨氮效果的影响,并采用GC-MS对蒸发冷凝液中有机物成分进行了分析鉴定.结果表明,生活垃圾沥滤液的初始pH对冷凝液中COD、氨氮含量及有机污染物分布产生了决定性的影响.沥滤液在酸性条件下(pH≤6)蒸发,随着pH的增加,冷凝液中COD的含量线性降低,而氨氮的含量线性增加.当沥滤液的初始pH值从6增加到11,冷凝液中COD的含量呈对数函数降低,而氨氮的含量表现出显著增加趋势.从冷凝液中鉴定出38种有机污染物,多为沸点较低的醇、酸、酚和酯类.在酸性条件下(pH=3),冷凝液中挥发性有机酸和低碳醇的相对丰度接近90％.在近中性条件下(pH=6.2),冷凝液中的有机污染物以酚、酸和杂环类化合物为主.在碱性条件下(pH =11),冷凝液中酚和杂环类化合物占比较高,而酸的含量极少.     

高效液相色谱-二极管阵列检测器测定邻苯二甲酸酯色谱条件优化

采用高效液相色谱-二极管阵列检测器对6种PAEs类物质进行测定,并对梯度洗脱条件、流速、检测波长等影响化合物色谱响应的关键参数进行优化。综合考虑样品测试效率、分析精度、实际样品中存在杂质干扰等因素,确定以乙腈-水为流动相进行梯度洗脱,洗脱0~11 min流动相乙腈-水梯度比例为50∶50,11 min后流动相调整为100%乙腈,各化合物均能完全分离;色谱分析流速为0.8 m L/min;PAEs的最佳吸收波长为225 nm。在优化的色谱条件下,6种PAEs的线性良好,相关系数均大于0.999 8,仪器检出限为0.08~0.12 mg/L,保留时间、峰面积的相对标准偏差分别为0.02%~0.60%、0.13%~0.86%。方法灵敏度较高,适合土壤等邻苯二甲酸酯含量较高基质样品的快速分析。     

固相萃取-高效液相色谱法测定废水中的酚类化合物

建立了Supelclean ENVI-Chrom P柱固相萃取-高效液相色谱法测定废水中11种酚类化合物的分析方法,并对固相萃取条件和液相色谱条件进行了讨论。该方法分离效果良好,净化效果明显,方法检出限为2×10-3~2×10-2mg/L,平行分析(n=6)的RSD为2.7%~16.4%,废水加标回收率除2,4-二硝基酚偏低以外,其他化合物的回收率为61.4%~115.8%。     

固相萃取-气质联用法测定固体废物浸出液中的二硝基苯

建立了一种利用固相萃取法对固体废物浸出液(TCLP)中二硝基苯进行萃取,DB-5石英毛细管柱(30 m×0.25 mm×0.25μm)进行分离,质谱检测器检测二硝基苯的方法。方法在0.002 0~0.020 0 mg/L之间线性关系良好,二硝基苯三种同分异构体的检出限均为0.5μg/L,模拟样品加标回收率为93%~96%,RSD≤2%;实际固体废物样品测定的加标回收率为95%~98%。     

On the search for mimetic patterns in environmental disclosure: an international perspective

In this paper, we assert and test the proposition that environmental disclosure (ED) is structured by institutionalised myths and that is why ED is decoupled from environmental performance and media pressures. Focusing on firms from Canada, France and Germany, findings show that ED mimetic isomorphism for different topics varies among countries and by industry sensitiveness to the environment. The results corroborate the institutional presumption that institutionalised myths vary among different contexts. Our findings also suggest that institutionalised ED structures may not reflect environmental performance, mimetic patterns being affected by environmental performance. However, the decoupling between ED mimetic isomorphism and environmental performance decrease when firms’ ED credibility is questioned by the media.