Spatial and Seasonal Variations of Water Quality in a Mediterranean Catchment: The Llobregat River (NE Spain)

The Llobregat and Ter Rivers, typical Mediterranean catchments in Northeast Spain, supply water to more than 4.5 million inhabitants residing in the metropolitan area of Barcelona. The objective of this work is to study the factors that influence the surface water quality of Llobregat catchment. As such, spatial and temporal variations of more 50 water chemical parameters were monitored in 10 sampling sites for a period that extended from July 1996 to December 2000. The temperature, pH and conductivity were measured at sites, whereas metals were analysed using ICP-OES and ICP-MS instrumental techniques. The head waters of the Llobregat River catchment flow through detrital Mesozoic-Cenozoic sedimentary rocks resulting in calcium bicarbonate-type water with low mineral content. The high water quality of the waterhead is deteriorated in the upper-middle part of the catchment due to: occurrence of evaporite-bearing geological formations, and the mining and industrial activities related to potash exploitation. As a result, an obvious increase in Na, K, Mg, Cl-, Br, Rb, and Sr concentrations is reported leading to a sodium (potassium) chloride water type. This saline hydrochemical fingerprint persists downstream. This important feature renders the low water quality of the Llobregat River to be adequate for drinking supply purposes. In addition, the industrial and residential activities, specially at the lower part of the catchment, increases P, B, Mn, Fe, Pb, Al, Cr, Co, Ni, Cu, Zn, As and Sb water concentrations.     

A cost worth paying: energetically expensive interactions with males protect females from intrasexual aggression

When approached by males, females of the Amarillo fish (Girardinichthys multiradiatus) perform a behaviour called vibration or they are aggressively challenged. We quantified vibration and assessed whether it compromises the rate of feeding attempts in dyads kept in outdoor enclosures. Male approaches resulted in female vibration and in a reduced feeding rate. Vibration was not evoked by female–female aggression, which was frequent and always ended in the subordinate fleeing from the dominant female. Using a closed respirometer we found that vibration is costly; oxygen consumption of females was greater in the presence of a male (which evoked vibration) than in the presence of a non-familiar female (when no vibration occurred). By recording interactions of females confined in aquaria in the presence and in the absence of males, we confirmed that escaping is the only available response to deal with female aggression. Females kept without males participated in frequent aggressive (even lethal) interactions that did not abate while the subordinate female was in sight of the dominant, and which caused premature births and injuries. Yet in the alternative treatment aggression ceased when a male approached, prompting vibration in both females. Thus, in the Amarillo, in as much as it evokes energetically costly female vibrations, male courtship is an expression of sexual conflict. However, in the absence of males, frequent female aggression potentially annuls the benefits of not vibrating. We propose that a complete appraisal of the consequences of sexual conflict must include an assessment of the costs imposed by intra-sexual interactions.     

Exergy analysis as a tool for the integration of very complex energy systems: The case of carbonation/calcination CO2 systems in existing coal power plants

A common characteristic of carbon capture and storage systems is the important energy consumption associated with the CO₂ capture process. This important drawback can be solved with the analysis, synthesis and optimization of this type of energy systems. The second law of thermodynamics has proved to be an essential tool in power and chemical plant optimization. The exergy analysis method has demonstrated good results in the synthesis of complex systems and efficiency improvements in energy applications.In this paper, a synthesis of pinch analysis and second law analysis is used to show the optimum window design of the integration of a calcium looping cycle into an existing coal power plant for CO₂ capture. Results demonstrate that exergy analysis is an essential aid to reduce energy penalties in CO₂ capture energy systems. In particular, for the case of carbonation/calcination CO₂ systems integrated in existing coal power plants, almost 40% of the additional exergy consumption is available in the form of heat. Accordingly, the efficiency of the capture cycle depends strongly on the possibility of using this heat to produce extra steam (live, reheat and medium pressure) to generate extra power at steam turbine. The synthesis of pinch and second law analysis could reduce the additional coal consumption due to CO₂ capture 2.5 times, from 217 to 85 MW.     

Performance comparison of commercial TiO2: separation and reuse for bacterial photo-inactivation and emerging pollutants photo-degradation

This research aims to compare the disinfection and degradation effectiveness in water of a commercial suspension of nano-TiO₂ (TiO₂Levenger) with the standard TiO₂Degussa P25. Photo-inactivation and photo-degradation experiments were conducted with UVA-vis light. Concerning the disinfection, the effects of TiO₂ dose (0–2 g/l), water matrix, bacterium type (Gram-positive or Gram-negative), and bacterial regrowth after the photo-treatments were studied for each catalyst. The experimental results show that Enterococcus sp. (Gram-positive) was more resistant to the photo-treatments than Escherichia coli (Gram-negative) for both catalyst; however, postirradiation trends showed similar behavior for both bacteria, favoring regrowth for short-treated cells and decay for longer-treated ones. Caffeine was selected as a model substance of pharmaceuticals and personal care products. In terms of caffeine removal, the effects of TiO₂ dose (0–2 g/l) and water matrix were analyzed. Besides, the comparison between mechanical coagulation-flocculation-decantation and simple decantation of TiO₂ was carried out. The results show that simple decantation allowed the recovery of 97.5% of TiO₂ Degussa P25 and TiO₂ Levenger within 1 day of simple decantation, while applying the proposed mechanical coagulation-flocculation decantation 99.7% of recovery of both catalysts was achieved in 2 hours. Finally, the subsequent reuse of both catalysts was proved with little loss of efficiency in terms of photo-disinfection during the four cycles. Nevertheless, the standard TiO₂ Degussa P25 photo-degradation efficiency of caffeine decreases considerably as compared to commercial suspension of TiO₂ Levenger concerning the reutilization.

     

Total arsenic accumulation in edible pods and seeds of Phaseolus vulgaris.

The main objective of this study was to evaluate whether arsenic accumulated in the edible pods and seeds of Phaseolus vulgaris, cv. Helda, above the Spanish maximum recommended concentration for food crops, 1 mg kg(-1) on a fresh weight basis. Only organic arsenicals were used because they are: a) the only arsenic species allowed for agricultural applications and b) more mobile than inorganic species. Selection of French beans, a sensitive plant to arsenic, was based on the fact that arsenic upward translocation is higher in sensitive than in tolerant plants. A 2 x 3 factorial experiment was conducted with two organic arsenic species: methylarsonic acid (MAA) or dimethylarsinic acid (DMAA) and three arsenic concentrations: 0.2, 0.5, or 1.0 mg L(-1). Arsenic phytotoxicity was primarily determined by soluble arsenic concentration. Experimental results showed that the low bean plant tolerance to arsenic is possibly due to the high arsenic upward transport to shoots, which could result in profound negative metabolic consequences. Even under extremely adverse conditions, arsenic residues in edible beans were below the maximum statutory limit set by the Spanish legislation. It can be concluded that the major danger of organic arsenical herbicides is that of decreased productivity rather than high arsenic uptake by consumers.     

Monitoring of drinking water treatment plants using ICP‐MS

More than sixty inorganic parameters were monitored in the Ter and Llobregat Drinking Water Treatment Plants (DWTPs) using ICP‐MS. Both DWTPs supply approximately four million inhabitants with water in Barcelona and neighbouring areas (NE Spain). The profile of inorganic parameters throughout the treatment process is similar in the Ter and Llobregat DWTPs. Sodium, K, Mg, Ca, Si, Cl^‐, SO₄ ^‐2, Li, Rb, Cs (only in the case of the Llobregat DWTP), Sr, Ba, B, Ti, Cr, V, Co, Ni, Zn, Cu, Sb, Mo, Pb and U were not removed from raw water. Consequently, no improvement was shown as regards the high salinity of Llobregat raw water which is related to the mining activities on the large salt deposits located in the upper part of the basin. However, P, Fe, Mn, Cu and As were removed during treatment. The results obtained reveal the suitability of ICP‐MS for inorganic water quality monitoring in DWTP.     

Concentrations and determinants of outdoor, indoor and personal nitrogen dioxide in pregnant women from two Spanish birth cohorts

Determinants of outdoor, indoor and personal concentrations of nitrogen dioxide (NO₂) were assessed in a subset of pregnant women of the Spanish INMA (Environment and Childhood) Study. Home indoor and outdoor NO₂ concentrations were measured during 48 h with passive samplers for 50 and 58 women from the INMA cohorts of Valencia and Sabadell, respectively. Women from Sabadell also carried personal NO₂ samplers during the same period. Data on time–activity patterns, socio-economic characteristics, and environmental exposures were obtained through questionnaires. Multiple linear regression models were developed to predict NO₂ levels.In Valencia, median outdoor NO₂ levels (42 µg/m³) were higher than median indoor levels (36 µg/m³). In Sabadell, personal NO₂ showed the highest median levels (40 µg/m³), followed by indoor (32 µg/m³) and outdoor (29 µg/m³) levels. Personal exposure to NO₂ correlated best with the indoor NO₂ levels. Temporal and traffic-related variables were significant predictors for outdoor NO₂ levels. Thirty-two percent of the indoor NO₂ variability in the two cohorts was explained by outdoor NO₂ levels and the use of the gas appliances. The model for personal exposure accounted for 59% of the variance in NO₂ levels in Sabadell with four predictor variables (outdoor and indoor NO₂ levels, time spent in outdoor environments and time exposed to a gas cooker). No significant association was found between personal or indoor NO₂ levels and exposure to environmental tobacco smoke (ETS) at home.Personal NO₂ levels were found to be strongly influenced by indoor NO₂ concentrations. The study supports the use of time–activity patterns along with indoor measurements to predict personal exposure to traffic-related air pollution.     

Pilot-scale biopesticide production by Bacillus thuringiensis subsp. kurstaki using starch industry wastewater as raw material

Pilot-scale Bacillus thuringiensis based biopesticide production (2000 L bioreactor) was conducted using starch industry wastewater (SIW) as a raw material using optimized operational parameters obtained in 15 L and 150 L fermenters. In pilot scale fermentation process the oxygen transfer rate is a major limiting factor for high product yield. Thus, the volumetric mass transfer coefficient (K_La) remains a tool to determine the oxygen transfer capacity [oxygen utilization rate (OUR) and oxygen transfer rate (OTR)] to obtain better bacterial growth rate and entomotoxicity in new bioreactor process optimization and scale-up. This study results demonstrated that the oxygen transfer rate in 2000 L bioreactor was better than 15 L and 150 L fermenters. The better oxygen transfer in 2000 L bioreactor augmented the bacterial growth [total cell (TC) and viable spore count (SC)] and delta-endotoxin yield. Prepared a stable biopesticide formulation for field use and its entomotoxicity was also evaluated. This study result corroborates the feasibility of industrial scale operation of biopesticide production using starch industry wastewater as raw material.     

Rheological profile of diets produced using agro-industrial wastes for rearing codling moth larvae for baculovirus biopesticides

A rheological study of diets using the agro-industrial wastes (brewery wastewater and pomace waste) was carried out in order to obtain a diet most adapted to supply nutrients for growth of codling moth (CM) larvae. Nutritive capacity (g/L) of brewery wastewater (BWW) (25.5 ± 5.5 carbohydrates; 16.9 ± 2.1 proteins; 6 ± 1.6 lipids) and pomace waste (POM) (22.0 ± 0.03 carbohydrates; 11.3 ± 1.3 proteins; 2 ± 0.2 lipids) were essential and important as replacement or in association with other ingredients [soya flour (SF), wheat germ (WG), yeast extract (YE)] of the standard diet for the breeding of codling moth larvae. These diet additives also contributed to the preservation of texture and nutritive content of larvae diet. The eggs and CM larvae were grown on alternate diets under industrial conditions (16:8 h photoperiod; 25 ± 1 °C and 50 ± 0.5 % of humidity). The higher assimilation of nutrients of the diets in BWW and control diet was observed by calculating the rate of hatching of eggs (0.48 to 0.71); larvae growth (0.23 to 0.4) and fertility (1.33 to 3 for control diet). The excellent growth and fertility rates of codling moth larvae were attributed to variations in viscosity (varying from 50 to 266 mPa.s?1), particle size (varying 24.3 μm in 88.05 μm with regard to 110 μm the control diet) and total solids (145.88 g/L POM + YE; 162.08 g/L BWW + YE; 162.2 g/L POM + WG; 173 g/L control; 174.3 g/L BWW + WG) diets. Lower viscosity favored improved diet due to ease of assimilation of nutrients. Thus, rheology is an important parameter during preparation of diets for growth of codling moth larvae as it will dictate the nutrient assimilation which is an important parameter of larvae growth.