Effects of long-term exposure to PM2.5 on years of life lost and expected life remaining in Ahvaz city,Iran (2008–2017)

Ambient air pollution is one of the most significant environmental problems, and many individuals around the world die each year prematurely from diseases caused by this type of pollution. PM_2.5 can transpire deep to the lungs and induce some dangerous health effects in humans. In this study, the health effects of long-term PM_2.5 were estimated on expected life remaining (ELR) and years of life lost (YLL) indices in Ahvaz city during the years 2008–2017 using the AirQ+ software developed by WHO. Values obtained from the PM_2.5 averaging, ELR, and YLL data were processed for the whole population in the age range of 0–64 and over 64. These values were entered into AirQ+ software. The mean annual concentration of PM_2.5 was highly variable, with the highest concentration being 70.72 μg/m³ in 2010 and the lowest 41.97 μg/m³ in 2014. In all studied years, the concentration of PM_2.5 with the variations between 4.2 to 7.07 times was higher than the WHO standard (10 μg/m³). Ahvaz city also did not experience any clean day during the 10-year period, and in 2010, there were 47 very unhealthy days and 27 dangerous days, i.e., the highest number of very unhealthy and dangerous days during the period. The results estimated that the highest and lowest YLL in the next 10 years for all ages groups would be 137,760.49 (2010) and 5035.52 (2014), respectively. Also, the ELR index was lower than the Iranian standard and EPA which was significantly correlated with the concentration of PM_2.5.

     

Statistical comparison and correlation of zinc and lead in estuarine sediments along the western coast of Mauritius

Cr, Zn and Pb were quantified using atomic absorption spectrometry (AAS) from urban and rural estuarine sediments collected along the western coast of Mauritius during the period July 2002-January 2003. The mean concentration of Cr (225.4 mg kg(-1)), Zn (107.0 mg kg(-1)) and Pb (27.0 mg kg(-1)) in sediments along the six estuaries can be considered below those from contaminated estuarine sediments. Zn and Pb were significantly higher in urban sediments downstream St. Louis River compared to a rural estuary at Tamarin at 5% significance level. Zn was also significantly lower in Tamarin compared to Petite Riviere Noire estuary. Cr was however not significantly different in sediments from the six estuaries and could be considered of basaltic origin and were correlated to neither lead nor zinc. The concentration of Zn and Pb were greatest in the more urbanised upper and lower reaches of the St. Louis estuary during the period of study and were also significantly positively correlated in the estuarine sediments indicating that the cycling of Pb and Zn were linked indicating a common source for Pb and Zn. The potential sources of Pb and Zn in the urban estuarine sediments were considered to arise from road runoff causing significant quantities to be trapped. At present, compared to contaminant levels found in the UK and elsewhere, Mauritius still looks relatively uncontaminated but there is growing concern about heavy metal contamination in urban estuaries. There is therefore a need for long-term studies in estuarine management to involve integrated strategies in which water-sediment interactions in estuaries need to be considered and international standards for sediment quality developed. Such studies undertaken in the future would further the understanding of the biogeochemical processes of estuarine systems in Mauritius which could then be used in environmental development schemes and effective coastal zone management.     

Antimony induces oxidative stress and cell death in normal hepatocytes

Antimony (Sb) accumulates in the liver which is one of the target organs for metal-mediated toxicity. Although toxicity of Sb was previously investigated, the precise mechanism of Sb-induced hepatotoxicity remains to be determined. The aim of this study was to examine the role of oxidative stress, and mitochondria in the induction of cell death by Sb. Our results showed that liver cell lysis induced by Sb is mediated by reactive oxygen species (ROS) formation, lipid peroxidation and decline of mitochondrial membrane potential (MMP). Antimony-induced ROS formation, lipid peroxidation and reduction of MMP were significantly diminished by antioxidants and ROS scavengers such as dimethyl sulfoxide and mannitol; mitochondrial permeability transition (MPT) pore sealing agents such as carnitine and trifluoperazine; and adenosine triphosphate (ATP) generator, L-glutamine. Antimony-induced ROS formation, lipid peroxidation and fall in MMP were potentiated by glutathione (GSH) depletion via n-bromoheptane. MPT pore sealing agents and ATP generator inhibited hepatotoxicity, indicating Sb-activated cell death via mitochondrial pathway. Pretreatment of hepatocytes with antioxidants and ROS scavengers also blocked cell death induced by Sb, whereas GSH depletion enhances Sb-induced cell death, suggesting that oxidative stress may be directly involved in the reduction of MMP. These findings contribute to a better understanding of the mechanisms that mediate Sb-induced cell death in isolated rat hepatocytes.     

Usage of polystyrene disposable food dishes in the lightweight concrete making

The increasing use and subsequent accumulation of polystyrene containers has triggered a substantial environmental problem. This study investigated using varied percentages of solid waste polystyrene disposable food dishes in the production of lightweight concrete samples with 350 kilograms per cubic meter (kg/m³) of cement and a density of 1,300 kg/m³. The polystyrene disposable dishes were ground into beads of 0–3 millimeters (mm) and 3–6 mm in size. First, the characteristics of Type II Portland cement, polystyrene, and aggregates were examined. The following characteristics of concrete using ASTM International and British Standards Institution standards were tested: slump, compressive strength, ability to resist chloride ion penetration, and resistance of concrete to rapid freezing and thawing cycles. Scanning electron microscopy (SEM) and energy dispersive X‐ray spectroscopy analytical techniques were also used. The slump of samples varied between 40 and 70 mm and was not dependent on either the polystyrene percentage or the size of the polystyrene beads in the concrete samples (p‐value > .05). The compressive strength of the concrete samples after 90 days of curing, and using different percentages of polystyrene, varied between 96 and 113 kilograms per square centimeter (kg/cm²). The resistance of the samples to the freezing and thawing cycle and chloride ion penetration were affected unfavorably by the presence of the polystyrene. The SEM technique indicated that concrete samples containing 15% and 25% polystyrene had denser crystals and less void than concrete samples with 40% and 55% polystyrene.     

Seasonal Fluctuation in Heavy Metal Pollution in Iran´s Siahroud River - A Preliminary Study (7 pp)

Background The management of its available water resources has become a key issue for Iran. During the last few decades, the water quality of Siahroud River in the coastal plain of the Caspian Sea in Gilan Province in Northern Iran has significantly degraded. The scarcity of water has been compounded by rapid population growth and increasing pollution from fertilizers, pesticides, and municipal and industrial wastes. One of the sources of this degradation is the movement of heavy metals from the river's watershed into the various water systems supported by the river, including the water system for Rasht City. Methods To study the magnitude of heavy metal pollution in the Siahroud River, seven heavy metals including Zn, Cu, Pb, Cd, Mn, Fe, and Ni were measured in duplicate from replicated water samples collected over five consecutive seasons and analyzed by Atomic Absorption Spectrometry. In situ measurements of pH were taken with the samples and total organic carbon (TOC) was analyzed by IR gas measurement. Results The results demonstrated that four of the seven heavy metals including Pb, Fe, Cd, and Mn exceeded permissible safe levels as established by the United States Environmental Protection Agency. Multivariate factor analysis suggested that industrial land-use was the main contributing factor for the high levels of Fe and Mn in the Siahroud River, whereas, Cd was principly from agricultural activities in the watershed. The data also suggested that pH and TOC had an important role in the behaviour of Pb and Mn, and that the elevated levels of these two heavy metals in Siahroud River was the consequence of other anthropogenic sources. Only negligible levels of Zn, Cu and Ni were detected. Finally, all the sampling stations were subjected to cluster analysis. The results indicated that three different zones could be distinguished according to the levels of pollution. In addition, it was shown that the urban areas did not have a significant impact on the heavy metal pollution in the river. This observation stems from the fact that the data from the sampling stations before and after Rasht City were not significantly different. Recommendation . Preventive measures need to be undertaken in the land-use systems and watersheds of the Siahroud River to reduce the pollution levels of Pb, Cd, Mn and Fe.     

Comparison of energy produced from waste by removing its different components: A case study of the waste landfill in Tehran

In developing and populated cities such as Tehran, a massive amount of municipal solid waste (MSW), both wet and dry, is transferred to landfills daily. Combustion is one of the most common methods of using mixed waste energy from the past to the present. The Dulong formula is widely used to calculate the energy released from MSW combustion. According to the constituent components of Tehran MSW, removing food waste leads to an increase in energy potential, which will be a suitable condition for energy production. In this work, the energy derived from the combustion of mixed and separated dry MSW generated in Tehran was calculated using the experimental Dulong formula and tables in Integrated Solid Waste Management (Tchobanoglous et al. 1993, McGraw‐Hill). The Dulong formula indicates that the use of Tehran mixed MSW (without separating materials for recycling) as a fuel source yields 8,966.40 KJ/kg while the use of Tchobanoglous et al. (1993) tables can generate 8,236 kJ/kg. By removing food waste and recyclable materials, the potential of energy production changes to 22,047 kJ/kg using the Dulong formula and 16,207 kJ/kg and the Tchobanoglous et al. (1993) tables. It indicates increase by 1.46 times and 46%, respectively. Regarding the 200‐ton capacity of the Tehran waste incinerator, the Dulong formula indicated generation of 4,409 MJ/day energy, and the Tchobanoglous et al. table presents 3,241 MJ/day. Therefore, considering that Tehran generates more than 4,000 tons of reject waste daily, it can easily be converted to energy rather than landfilled. This can alleviate the problem of buying land and construction of landfills and leachate generation.     

Analysis of stability of silica nano-particle-laden microbubble dispersion

Microbubbles are small gas-filled bubbles which have wide application in various industries. The stability of microbubble is of primary concern for the application of microbubble. In this research, the stability of microbubble dispersion generated using CTAB surfactant is analyzed by drainage mechanism. The stability of microbubble dispersion is studied on the basis of the half-life of microbubble dispersion. Microbubble dispersion gas fraction and apparent rise velocity of interface of microbubble dispersion are also calculated. The size of microbubble is estimated from the apparent rise velocity of interface of microbubble dispersion. Further, silica nano-particles are added to the surfactants to study their effect on the stability of microbubble dispersion. The observed results clearly indicate that the stability of microbubble dispersion is significantly affected by the surfactant concentration and the weight of silica nano-particle in the liquid. Similar results were observed for the apparent rise velocity of interface and bubble size of dispersion. The present work may be beneficial for the application of microbubble in various chemical and biochemical industries and scientific community.

     

Environmental life cycle assessment of different types of the municipal wastewater pipeline network

With the onset of social life, humans have considered waste disposal as essential, and they have been able to repel it through brick and clay channels. Checking sewage pipes for energy consumption and a longer lifetime than other sewage system components is important. Climate change and exploitation of industrial resources have made environmental impacts, which are important factors in decision making. The purpose of this study was to introduce the most suitable type of sewage pipe considering environmental protection. Therefore, we applied the environmental life cycle assessment (LCA) method, using Sima Pro 8.2.3 software for the one-kilometer length of concrete pipes (300 mm in diameter), Polyvinyl chloride (PVC), and polyethylene (PE) (315 mm in diameter). Also, the BEES method and sensitivity analysis were used to validate the results. The comparison between three types of municipal wastewater pipes indicated that PE pipes are a more environmentally friendly option than PVC, and concrete pipes in pipe recycling, reducing extraction from untapped resources, and inefficient extraction of resources. Electricity, diesel fuel, and sulfate resistance cement consumption for concrete production are the most pollution elements in the LCA of concrete pipes. Usage of PVC granular, sanitary landfill of PVC pipes, and using hydraulic drill in LCA of PVC pipes are the most elements of generating pollution. The usage of PE granules, PE pipes landfilling, hydraulic excavator, and electricity consumption in the LCA of the PE pipes are the greatest polluting parameters.     

Applications of nanomaterials in water treatment and environmental remediation

Nanotechnology has revolutionized plethora of scientific and technological fields; environmental safety is no exception. One of the most promising and well- developed environmental applications of nanotechnology has been in water remediation and treatment where different nanomaterials can help purify water through different mechanisms including adsorption of heavy metals and other pollutants, removal and inactivation of patho- gens and transformation of toxic materials into less toxic compounds. For this purpose, nanomaterials have been produced in different shapes, integrated into various composites and functionalized with active components. Nanomaterials have also been incorporated in nanostructured catalytic membranes which can in turn help enhance water treatment. In this article, we have provided a succinct review of the most common and popular nanomaterials （titania, carbon nanotubes （CNTs）, zero-valent iron, dendrimers and silver nanomaterials） which are currently used in environmental remediation and particularly in water purification. The catalytic properties and functionalities of the mentioned materials have also been discussed.