Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

Ti/SnO2-Sb2O5/PbO2阳极电化学氧化降解苯甲酸研究

文章研究了TI/SnO2-Sb2O5/Pbo2在两室电解池中氧化降解苯甲酸的性能,主要考察了电流密度、初始pH值、初始苯甲酸浓度和支持电解质这四个参数对TOC去除效率的影响。实验表明在电流密度为30 mA/cm2,初始苯甲酸浓度为0.5 mmol/L,支持电解质(Na2SO4)为0.1mol/L的条件下,经过6 h反应...     

改性Ti/SnO2-Sb电极催化降解1,4-二氯苯废水试验研究

采用聚合物前驱体法制备了未掺杂、掺杂Cu、掺杂Bi、掺杂Ni的4种Ti/Sn O2-Sb电极,运用SEM和XRD分析电极表面形貌及结构,通过线性极化扫描、循环伏安等测试考察其电化学性能,同时进行1,4二氯苯(p-DCB)降解实验进一步探究电极的电催化氧化特性.SEM和XRD结果表明,掺杂金属可改善电极表面形貌,增大其比表面积;电化学测试表明,Ti/Sn O2-Sb电极的析氧电位并未因金属掺杂而有明显改变,掺杂金属后,Ti/Sn O2-Sb电极具有更优的电催化活性和稳定性.p-DCB降解实验表明,改性Ti/Sn O2-Sb电极对p-DCB的降解效率明显提高,其中Ti/Sn O2-Sb-Cu电极的电催化处理效果最优,电解2 h后p-DCB的去除率即达到87.6%,且p-DCB的降解反应遵循一级反应动力学规律.     

改性钛基PbO2电极对有机污染物的降解性能——以甲基橙和4-硝基苯酚为例

采用溶胶-凝胶法和电化学沉积法制备了Ti/SnO₂-Sb/Ce-PbO₂电极,并对制备的电极表面形貌、晶体结构和电化学性能进行了分析,进一步探究了该电极对甲基橙和4-硝基苯酚的降解效果.结果表明,由Ce改性的Ti/SnO₂-Sb/Ce-PbO₂电极具有稳定的结构和更好的电化学活性,析氧电位可达1.56V.在电极间距为2cm,电流密度为30mA/cm²,目标污染物的浓度为100mg/L,电解质浓度为0.10mol/L时,作用120min后,Ti/SnO₂-Sb/Ce-PbO₂电极对甲基橙和4-硝基苯酚的降解率分别达到了99.59%和96.16%,180min后TOC的去除率分别达到了56.71%和54.87%,研究结果为该电极降解有机污染物提供了一定的技术支撑.     

Ti/SnO2-RuO2-Sb电极电氧化处理五氯苯酚模拟废水研究

采用刷涂-热解法制备了Sb、Ru掺杂的Ti/SnO2电极。通过SEM、EDX、XRD和循环伏安扫描(CV)表征了电极表面形态、组成、结构和电化学性质,并通过正交试验考察了电催化氧化降解五氯苯酚的影响因素。结果表明,各因素对五氯苯酚转化率影响的大小顺序依次为:底物初始质量浓度、反应温度、反应时间、电流密度、初始溶液pH值。在底物质量浓度为50mg.L-1,反应温度50℃,反应时间180min,电流密度40mA.cm-2,溶液初始pH值为8的条件下五氯苯酚的转化率达到97.6%。     

A high activity of Ti/SnO2-Sb electrode in the electrochemical degradation of 2,4-dichlorophenol in aqueous solution

Electrochemical degradation of 2,4-dichlorophenol (2,4-DCP) in aqueous solution was investigated over Ti/SnO₂-Sb anode. The factors influencing the degradation rate, such as applied current density (2-40 mA/cm²), pH (3-11) and initial concentration (5-200 mg/L) were evaluated. The degradation of 2,4-DCP followed apparent pseudo first-order kinetics. The degradation ratio on Ti/SnO₂-Sb anode attained > 99.9% after 20 min of electrolysis at initial 5-200 mg/L concentrations at a constant current density of 30 mA/cm² with a 10 mmol/L sodium sulphate (Na2SO4) supporting electrolyte solution. The results showed that 2,4-DCP (100 mg/L) degradation and total organic carbon (TOC) removal ratio achieved 99.9% and 92.8%, respectively, at the optimal conditions after 30 min electrolysis. Under this condition, the degradation rate constant (k) and the degradation half-life (t_1/2) were 0.21 min^-1 and (2.8±0.2) min, respectively. Mainly carboxylic acids (propanoic acid, maleic acid, propanedioic acid, acetic acid and oxalic acid) were detected as intermediates. The energy efficiencies for 2,4-DCP degradation (5-200 mg/L) with Ti/SnO₂-Sb anode ranged from 0.672 to 1.602 g/kWh. The Ti/SnO₂-Sb anode with a high activity to rapid organic oxidation could be employed to degrade chlorophenols, particularly 2,4-DCP in wastewater.