厌氧水解酸化-生物接触氧化工艺处理印染废水

印染废水的色度大,有机物含量高,可生化性差。针对这些特点,采用了厌氧水解酸化-生物接触氧化、气浮等工艺处理印染废水,结果表明,该工艺对印染废水有很好的处理效果,最终出水基本无色,达到纺织染整工业水污染物排放的一级标准（GB4287--1992）,处理成本较低。     

内电解-水解酸化-接触氧化-氧化絮凝处理印染废水研究

采用内电解-水解酸化-接触氧化-氧化絮凝处理印染废水,考察了内电解反应中进水pH、反应时间、反应温度、鲍尔环填料中铁粉与焦炭质量比(简称Fe/C)对废水COD和色度去除效果的影响;在实验所得最佳条件下,内电解反应对废水中NH3-N和TP的去除效果;水解酸化-接触氧化对内电解出水的COD和NH3-N的去除效果及反应前后的...     

混凝-水解-接触氧化-气浮工艺处理印染废水

采用混凝-水解酸化-接触氧化-气浮工艺,处理印染废水,运行结果表明：对CODcr SS、色度的去除率分别为91．5％、92％、90％,出水达到《纺织染整工业水污染排放标准》（GB4287—92）的一级标准。     

混凝-生物接触氧化-臭氧氧化工艺对印染废水处理特性评价

评价了大塘污水处理厂混凝-生物接触氧化-臭氧氧化工艺对印染废水的处理特性,分析处理过程中COD、色度的去除规律。结果表明:混凝-生物接触氧化-臭氧氧化工艺出水COD浓度最优水平值(TPSs-3.84%)为18.7 mg/L,中间水平浓度(TPSs-50%)为45 mg/L,COD浓度保证值(TPSs-95%)为62.7 mg/L,优于排放标准;工艺出水色度最优水平值(TPSs-3.84%)为10倍,中间水平浓度(TPSs-50%)为40倍,出水保证值(TPSs-95%)为45倍。其中,臭氧氧化在印染废水出水COD和色度的深度处理中发挥重要作用,将出水COD达标保障率由原来的91%提高到100%、出水色度的达标保障率由0%提高到90%。     

生物铁-接触氧化组合技术处理抗生素制药废水

采用生物铁-接触氧化组合技术,研究各单元工艺和组合工艺的处理抗生素制药废水的效果、最佳控制参数和操作条件。结果表明,其CODCr去除率可超过90％,经处理后的出水可达到工厂回用水的水质要求,是处理抗生素制药废水行之有效的方法。     

生物接触氧化法处理印染废水的工程设计

介绍了生物接触氧化法处理印染废水的工程设计实例，处理后的废水水质能达到设计要求。     

混凝-氧化法处理印染废水

采用混凝 氧化法对印染废水进行处理 ,得出最佳混凝条件及氧化条件。实验结果表明 ,该法可使印染废水的CODCr与色度去除率分别达到 90 .2 %和 99.1%。该方法具有去除率高、操作方便、设备简单、不产生二次污染等优点。     

絮凝-Fenton试剂氧化处理印染废水

采用Fenton试剂对某染袜厂2种印染废水(印染红和印染蓝)进行处理。考察了硫酸亚铁投加量、双氧水投加量、反应时间及pH值对印染废水的色度及COD去除率的影响,通过正交实验确定了Fenton试剂处理该废水的最佳操作条件为:反应时间30 min、双氧水(30%)投加量4 mL/L、硫酸亚铁投加量300 mg/L、pH值为4左右。在最佳条件下,印染蓝废水经氧化处理后COD去除率大于80%,色度去除率95%以上;印染红废水需经絮凝预处理后再用Fenton试剂氧化处理,其脱色率达到了99.6%,COD去除率为91.2%,出水COD浓度为96 mg/L,可达标排放。     

印染废水催化湿式氧化法处理中水质酸碱度的变化

以初始质量浓度为1088 mg/L、色度为30万倍的亚甲蓝溶液模拟印染废水进行实验,系统考察了印染废水催化湿式氧化(CWAO)法处理中水质酸碱度的变化.结果表明,处理后出水pH呈先降低后升高的趋势,而且反应前期pH降低的幅度大,反应后期pH升高的幅度小;出水中pH最低点随CulFel催化剂(Cu2+、Fe2+质量比为1:1)投加量的增加、氧分压的升高、进水pH的降低而降低;反应温度越高,出水pH越先达到最低点;反应终点出水pH随CulFel催化剂投加量的增加、氧分压的升高、反应温度的升高、进水pH的升高而升高.     

生物接触氧化工艺处理印染废水

在常温条件下,采用兼氧、好氧生物接触氧化-气浮工艺处理高浓度印染废水,结果表明,CODcr去除率为95％,色度去除率为90％。该工艺具有占地面积小、脱色效果好、处理效率高等特点,能广泛应用于纺织印染废水的实际工程中。     

Optimization of Height of Release of Air Pollutants

A number of key projects in the Environmental Protection Agency (EPA) particulate R&;D program having applicability to industry are presented. For electrostatic precipitators (ESP) there is presented the result of work on large diameter discharge electrodes which provide a decrease in penetration of up to a factor of 4 when compared to conventional small diameter electrodes. Also discussed is the multistage ESP which provides a collection efficiency that would require a collecting plate area 4 or 5 times larger with conventional ESP technology. The E-SOX technology makes use of the multistage concept to free up space in the ESP for SO₂ removals of up to 90%. Electrostatically augmented fabric filtration provides a reduction in pressure drop of about 5 0% as compared to conventional fabric filtration. Wind tunnel modeling of windbreaks for material storage piles indicates a potential for providing engineering design data that would allow significant emission reduction caused by wind erosion     

Investigation of the characteristics of the reflectivity of clouds

This paper investigates some of the reflectivity characteristics that clouds (when modelled as solid bodies) must exhibit to be compatible with observations that the reflecting surface of a cloud (i) appears almost equally bright across its face, (ii) is brightest when the cloud is opposite to the Sun but decreases in brightness as the cloud moves to other positions and (iii) increases in brightness with increasing optical thickness of the cloud in the observer's line of sight. These observations, respectively, are shown to imply that the peak value of the bidirectional total reflectivity from a cloud surface (i) increases in inverse proportion to the cosine of the angle between the Sun and the normal to the cloud surface, as the incident angle increases, (ii) appears to be directed back in the direction of the incident radiation, and (iii) increases as optical thickness of the cloud in the observer's line of sight increases. The results could have application in many fields (e.g. modelling diffuse radiance distributions for cloudy skies).     

Estimation of uncertainty of sampling for analysis of pesticide residues

Abstract

A computer model was used to take random samples from primary sample populations obtained from field trials to simulate the uncertainty of sampling for residue analysis of plant commodities and soil. The results indicate about 40%, 30% and 20% relative uncertainty when random samples of size 5, 10 and 25 are taken respectively, from a single lot. Therefore the sample size should be the same for establishing and enforcing legal limits.     

扬中生态环境建设的思考与实践

结合扬中生态环境的基本情况和存在的不足，进行了具体分析，对扬中未来生态建设的发展方向提出了建议及实施措施。     

实验室质量管理体系内部审核的实施

在实施ISO／IEC17025：1999标准《检测和校准实验室能力的通用要求》过程中，通过实验室质量管理体系内部审核的实践与系统分析，识别出内部审核实施阶段的关键环节，提出召开首次会议、收集审核证据、确定审核发现和召开末次会议的技术方法，对提高内部审核的质量和有效性、获得可靠的审核结论具有重要意义。     

次氯酸钠发生器的研制

介绍了电解法生产次氯酸钠的原理 ,并在原有生产工艺的基础上进行了重新设计和对设备的重新选择、改造 ,得出了各个工艺参数的最佳值 ,生产出高品质的次氯酸钠     

An application of the theory of kinematics of mixing to the study of tropospheric dispersion

The most common technique used for numerical simulations of tracer mixing is that of the numerical solution of the advection–diffusion equation with the unresolved fluxes parameterized using the similarity theory. Despite correct predictions of the overall directions of transport, models based on a numerical solution of the advection–diffusion equation lack sufficient accuracy to correctly reproduce the coupling of mixing with small scale processes which are sensitive to the microstructure of the tracer distribution. The objective of this paper is to revisit the basic formalism employed in numerical models used to investigate atmospheric tracers. The main mathematical method proposed here is the theory of kinematics of mixing which could be applied effectively for simulations of atmospheric transport processes. At the beginning of the paper, we introduce simple mathematical transformations in order to demonstrate how complex topological structures are created by mixing processes. These idealistic flow systems are essential to explain transport properties of much more complex three-dimensional geophysical flows. An example of the application of the kinematics of mixing to the analysis of tracer transport on a planetary scale is presented in the following sections. The complex filamentary structures simulated in the numerical experiment are evaluated using some commonly applied statistical measures in order to compare the results with the data published in the literature. The results of the experiment are also analysed with the help of simple conceptual models of fluid filaments. The microstructure of the tracer distribution introduced in the paper is essential to increase our understanding of atmospheric transport and to develop more realistic parameterizations of small-scale mixing. The presented results could also be used to improve calculations of the coupling between microphysical processes and tracer mixing.     

Impact of overexploitation of shellfish: northeastern coast of India

India has a very extensive coastline of about 7515 km, rich in diverse living resources. These resources continue to deteriorate with rampant harvesting or are altered for other uses such as aquaculture and fisheries. The present paper deals with degrading coastal habitats in northeastern India, and projects the intensity of the stress arising from the collection of tiger prawn seeds (Penaeus monodon) for aquacultural farms and molluskan shells for poultry feed and edible lime. Indiscriminate exploitation of these resources leads to a heavy reduction of the species concerned and other associated marine communities. The magnitude of such destruction has been quantified. The impacts of biodiversity loss and their after-effects on the ecobalance of this coastal system have become a matter of great concern to ecologists to maintain security and sustainability. The authors propose a public awareness program on themes relating to the importance of biodiversity for human livelihoods.     

Comparison of methods for evaluation of activity of photocatalytic films

Objective

This work aims to investigate the correlation between the photocatalytic activity determined by methylene blue bleaching (DIN 52980), stearic acid degradation, and degradation of acetone in gas phase.

Method

The photocatalytic TiO₂ coatings included in this investigation ranged from thin commercially available coatings (Activ^TM and BioClean^TM) and ready to use suspensions (Nano-X PK1245) to lab-produced PVD and sol?Cgel coatings. XRD analysis of the photocatalytic coatings showed that all the coatings consisted of nanocrystalline anatase, although the thickness and porosity varied considerably.

Results

The study showed that the reproducibility of the activity measurements was good. However, more importantly, the investigation showed that there is a good correlation between the activities determined by the different methods even though the characteristics of the photocatalytic coatings and the organic probe molecules varied considerably.

Conclusion

The overall findings of this work suggest that there is a good correlation between the investigated methods. These results are promising for the future work concerning standardization of methods for determination of the activity of photocatalytic films.