G20峰会期间杭州地区空气质量特征及气象条件分析

利用空气质量和气象要素的监测资料与再分析资料,分析了2016年G20峰会期间(2016年8月10日—9月20日)杭州及周边地区空气质量演变及区域特征,探讨了气象条件对G20峰会期间杭州空气质量的影响.结果表明:G20峰会管控期间,由于机动车排放大幅度降低,杭州NO_2浓度较管控前有所下降,对比周边城市降幅居于首位;而由于不利气象条件的影响,PM_(2.5)、PM_(10)、SO_2、CO和O_3浓度比管控前有不同程度的增长,但增幅相比周边城市较小,说明管控措施对杭州空气质量有一定的改善效果.9月7日管控措施结束后污染反弹现象明显.气象条件对杭州的空气质量有重要影响:在管控前,杭州晴热高温天气有利于O3的生成,偏东风相对洁净,污染传输较少;在管控期,杭州虽受到静稳天气和外来污染传输的影响,但得益于减排应急管控措施的有效实施,NO_2浓度下降幅度最大,其他污染物的增幅也较周边城市偏小;在管控后,气象条件不利于污染物的垂直扩散,受静稳天气和污染源恢复常态的影响,PM_(2.5)、PM_(10)、NO_2、SO_2和CO出现了整个研究时段的最大值,而台风"莫兰蒂"使得杭州PM_(2.5)、PM_(10)和O_3浓度出现了整个研究时段的最低值.     

微波诱导AC/Cu、AC/Fe催化非均相Fenton 反应催化降解垃圾渗滤液

采用活性炭载体负载Cu、Fe为催化剂,在微波诱导作用下,对垃圾渗滤液污染物进行降解。实验结果表明,活性炭负载金属前经适当浓度硝酸浸泡处理后,催化剂对COD去除率提高可超过15%,过高硝酸盐浓度对COD去除有不利影响;催化剂对COD去除率随Cu、Fe金属负载量增加呈先增加后降低的趋势,催化剂对Cu、Fe的最佳负载量分别为质量百分比2.11%和1.12%。对于AC-Cu体系,在初始pH=3,H2O2投加量为4.98×103mg/L,催化剂用量为5.0×103mg/L,420 W功率下微波辐射10 min时,垃圾渗滤液COD去除率可达到84.13%;对于AC-Fe体系,当H2O2投加量为0.33×103mg/L,催化剂AC-Fe用量为2.0×104mg/L,420 W功率下微波作用10 min时,垃圾渗滤液COD去除率为60.16%。分析2种催化剂对COD去除差异的原因,可能是催化剂AC-Cu表面单分子分布的阈值比AC-Fe高。降解液的pH值对AC-Cu体系、AC-Fe体系COD去除影响存在拐点,最高COD去除率点对应的降解液pH值为3。微波辐射功率较低时,体系COD去除率随辐射功率增加而增加;辐射功率较高时,高温下垃圾渗滤液中有机硫化物分解成小分子硫化物,对催化剂活性存在一定抑制作用。     

江苏省污染减排与空气质量变化相关性分析

利用2000—2007年大气污染物排放量数据和同期环境空气质量监测数据,分析了江苏省主要大气污染物减排与环境空气质量变化的相关性。结果表明,近年来江苏省SO2排放量与环境空气中SO2浓度存在正相关,而烟尘和粉尘排放总量与空气中可吸入颗粒物的浓度呈现出弱的负相关关系。对江苏省经济发展和环境关系的进一步分析揭示,江苏省环境库兹涅茨曲线呈现出倒U型关系,表明江苏省已经进入经济环境双赢区间,但近年来政策对经济环境关系的影响突出。该研究对中国十二五环境管理政策的制定有着重要的参考意义。     

Multi-response optimization of Fenton process for applicability assessment in landfill leachate treatment

Fenton process, as a pretreatment method, was found to be effective in the primary treatment of mature/medium landfill leachate. However, the main problem of the process is the large amount of produced sludge that requires an accurate feasibility evaluation for operational applications. In this study, the response surface methodology was applied for the modeling and optimization of Fenton process in three target responses, (1) overall COD removal, (2) sludge to iron ratio (SIR) and (3) organics removal to sludge ratio (ORSR), where the latter two were new self-defined responses for prediction of sludge generation and applicability assessment of the process, respectively. The effective variables included the initial pH, [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage. According to the statistical analysis, all the proposed models were adequate (with adjusted R² of 0.9116–0.9512) and had considerable predictive capability (with prediction R² up to 0.9092 and appropriate adequate precision). It was found that all the variables had significant effects on the responses, specifically by their observed role in dominant oxidation mechanism. The optimum operational conditions obtained by overlay plot, were found to be initial pH of 5.7, [H₂O₂]/[Fe²⁺] ratio of 17.72 and [Fe²⁺] of 195 mM, which led to 69% COD removal, 2.4 (l sludge/consumed mole Fe²⁺) of SIR and 16.5 (gCOD removed/l produced sludge) for ORSR in verification test, in accordance with models-predicted values. Finally, it was observed that [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage had significant influence on COD removal, while Fe²⁺ dosage and [H₂O₂]/[Fe²⁺] ratio had remarkable effects on SIR and ORSR responses, respectively.     

Evaluation of Existing and Modified Wetland Equations in the SWAT Model

The ability to accurately simulate flow and nutrient removal in treatment wetlands within an agricultural, watershed‐scale model is needed to develop effective plans for meeting nutrient reduction goals associated with protection of drinking water supplies and reduction of the Gulf of Mexico hypoxic zone. The objectives of this study were to incorporate new equations for wetland hydrology and nutrient removal in Soil and Water Assessment Tool (SWAT), compare model performance using original and improved equations, and evaluate the ramifications of errors in watershed and tile drain simulation on prediction of NO₃‐N dynamics in wetlands. The modified equations produced Nash‐Sutcliffe Efficiency values of 0.88 to 0.99 for daily NO₃‐N load predictions, and percent bias values generally less than 6%. However, statistical improvement over the original equations was marginal and both old and new equations provided accurate simulations. The new equations reduce the model's dependence on detailed monitoring data and hydrologic calibration. Additionally, the modified equations increase SWAT's versatility by incorporating a weir equation and an irreducible nutrient concentration and temperature coefficient. Model improvements enhance the utility of SWAT for simulating flow and nutrients in wetlands and other impoundments, although performance is limited by the accuracy of inflow and NO₃‐N predictions from the contributing watershed. Editor's note : This paper is part of the featured series on SWAT Applications for Emerging Hydrologic and Water Quality Challenges. See the February 2017 issue for the introduction and background to the series.     

催化裂解法处理有机硅高沸物

采用催化裂解法处理有机硅高沸物,解决高沸物储存过程中的安全、环保问题。研究了催化剂种类、HCl加入量和精馏高沸物加入量对高沸物转化率的影响。实验结果表明:在以N,N-二丁基-1-丁胺为催化剂、合成高沸物为原料、HCl加入量为13%(w)的条件下,高沸物转化率为83.10%,二甲基二氯硅烷收率为23.78%;合成高沸物中精馏高沸物加入量为9.0%(w)时,高沸物转化率最高,为85.58%。     

城市防震减灾能力评估研究

首先论述了目前国内外关于城市地震灾害风险评估的研究，分析了这些研究取得的成果和存在的不足。然后，提出了城市防震减灾能力的概念，采用人员伤亡，经济损失和震后恢复时间作为衡量城市防震减灾能力强弱的3个最基本的要素。围绕这3个基本要素，列举出影响城市防震减灾能力的6大因素，在此基础上，提出了城市防震减灾能力评价指标体系的具体内容。     

CuO（-CeO2）/SBA-15对萘氧化的催化活性及CO2选择性研究

通过浸渍法制备CuO/SBA-15和CuO-CeO2/SBA-15两种介孔材料催化剂,采用BET、XRD、TPR和XPS等对催化剂进行表征,重点考察催化剂对萘氧化反应的催化活性及对产物CO2的选择性。BET、XRD和XPS等实验结果表明CuO高度分散于介孔分子筛SBA-15中,CeO2可促进CuO在载体上的分散,同时能降低催化剂的TPR还原温度。活性测试结果表明CuO/SBA-15对萘氧化反应的催化活性较高,但是催化氧化的CO2选择性较低,温度在380℃时CO2的生成率仅为60%左右;CeO2的添加不仅提高了CO2的生成率,15%CuO-15%CeO2/SBA-15在325℃使CO2生成率达到99%,而且CeO2增强了催化剂的稳定性。     

超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

CuO / 过硫酸氢钾体系催化氧化苯酚简

本论文通过直接沉淀法制备了CuO催化剂，结合过硫酸氢钾，在常温常压下催化氧化处理苯酚模拟废水。采用电子显微镜（SEM）、X射线粉末衍射（XRD）对催化剂进行了表征，并研究了反应过程中各影响因素对降解效率的影响。实验结果表明，在催化剂用量为0.2 g/L，氧化剂浓度为0.25 g/L，pH值为7，反应时间为60 min的条件下，浓度为50 mg/L的苯酚降解率可达100%，TOC去除率达84%。进一步实验表明，催化剂具有良好的重复使用能力。最后，通过自由基捕捉实验，考察了体系中的自由基种类，并根据实验结果，讨论了CuO/过硫酸氢钾体系的催化降解机理。