Feasibility of honeycomb monolith supported sugar catalyst to produce biodiesel from palm fatty acid distillate (PFAD)

Carbon coated monolith was prepared by sucrose solution 65 wt.% via dip-coating method. Sulfonation of incomplete carbonized carbon coated monolith was carried out in order to synthesize solid acid catalyst. The textural structure characteristics of the solid acid catalyst demonstrated a low surface area and pore volume. Palm fatty acid distillate (PFAD), a by-product of palm oil refineries, was utilized as oil source in biodiesel production. The esterification reaction subjected to different reaction conditions was performed by using the sulfonated carbon coated monolith as heterogeneous catalyst. The sulfonation process had been performed by using vapour of concentrated H₂SO₄ that was much easier and efficient than liquid phase sulfonation. Total acidity value of carbon coated monolith was measured for unsulfonated sample (0.5 mmol/g) and sulfonated sample (4.2 mmol/g). The effect of methanol/oil ratio, catalyst amount and reaction time were examined. The maximum methyl ester content was 89% at the optimum condition, i.e. methanol/oil molar ratio (15:1), catalyst amount (2.5 wt.% with respect to PFAD), reaction time (240 min) and temperature 80 °C. The sugar catalyst supported on the honeycomb monolith showed comparable reactivity compared with the sugar catalyst powder. However, the catalyst reusability studies showed decrease in FFA% conversion from 95.3% to 68.8% after four cycles as well as the total acidity of catalyst dropped from the value 4.2 to 3.1 mmol/g during these cycles. This might be likely due to the leaching out of SO₃H group from the sulfonated carbon coated monolith surface. The leaching of active species reached a plateau state after fourth cycle.     

固相萃取-气质联用法测定固体废物浸出液中的二硝基苯

建立了一种利用固相萃取法对固体废物浸出液(TCLP)中二硝基苯进行萃取,DB-5石英毛细管柱(30 m×0.25 mm×0.25μm)进行分离,质谱检测器检测二硝基苯的方法。方法在0.002 0~0.020 0 mg/L之间线性关系良好,二硝基苯三种同分异构体的检出限均为0.5μg/L,模拟样品加标回收率为93%~96%,RSD≤2%;实际固体废物样品测定的加标回收率为95%~98%。     

基于腔衰减相移光谱法的二氧化氮分析仪的设计与应用

基于腔衰减相移光谱法设计了一套二氧化氮在线分析仪,通过优化测量参数,该仪器可长期稳定运行,其时间分辨率为60 s,检出限为0.191 ppb,在0~300 ppb范围内,NO₂气体浓度与相位正切信号值具有较好的二次拟合关系,R²为0.9995.另外,该仪器在泰安站进行了长期外场观测,并与改装后的进口商品化仪器PKU-Thermo 42i-TL进行比对实验,结果表明,两者的测量结果一致性较好,R²=0.9811,表明其具有良好的运行稳定性和测定结果准确性,适用于环境大气二氧化氮浓度的在线监测.外场观测结果表明,春季泰安站二氧化氮浓度均值为12.39 ppb,有明显日变化规律.     

NOx存在条件下相对湿度对甲苯氧化产物的影响

利用流动管反应器模拟甲苯与氧化剂×OH在NO_x存在条件下的反应,定量测定了不同相对湿度条件下（17.5%、35%、50%、70%）反应生成的部分气相产物和颗粒相产物,计算了不同相中产物产率,测量了不同相对湿度下的颗粒相有机碳（OC）产率,推导了相对湿度对甲苯氧化反应的影响机制.结果表明,相对湿度不仅对甲苯与×OH反应途径比例有影响,还对产物的产率及氧化程度有影响.     

基于高分1号影像的森林植被信息提取

实时最新森林植被信息的提取是林业航空植保作业的必要前提。论文以安徽省蚌埠市为研究区域,探讨了基于高分1号卫星遥感数据在亚热带农林植被混合地区的森林植被信息提取。根据植被物候信息差异选择了提取森林植被信息的5个关键时期高分影像,采用分区决策树方法监测森林植被的空间分布和面积信息,并与未分区决策树法的提取结果进行比较。结果表明：采用分区决策树法和未分区决策树法对于大中尺度森林植被信息提取的总体精度均优于85%。但分区决策树森林植被提取总体精度达到90.72%,较未分区决策树法提高3.80%、4.65%,Kappa系数达到0.81,较未分区决策树法提高约0.07~0.10,结合植被物候信息的分区决策树森林植被提取法好于未分区决策树法,能够满足林业航空植保作业的精度需求。具有较高空间分辨率、宽覆盖、短重访周期的高分1号影像,对于大区域的林业航空植保当年最新森林植被信息的提取表现出较大的潜力。     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

纳米TiO2/CNTs复合材料的制备及其光学性质

TiO2在碳纳米管上的复合材料可以增加材料的光催化性能,已成为新的研究热点.本文采用低温液相法成功地合成了TiO2/CNTs复合材料,并用TEM、XRD和UV-vis对材料进行了表征,结果表明,TiO2很好地分散在CNTs上,具有显著的催化效果,有很好的应用前景.     

固相微萃取-毛细管气相色谱法快速同步分析水中有机氯及有机磷农药

固相微萃取是一种快速、简便,集萃取浓缩进样于一体的样品前处理技术,具有分析时间短、灵敏度高、无需有机溶剂的优点.用固相微萃取富集水中8种有机氯及7种有机磷农药,毛细管气相色谱ECD检测器分离分析,整个分析过程只需26min,检出限可达0.002～1μg/L,已用于地表水中有机氯及有机磷农药含量的测定.     

膜、柱串联固相萃取-高效液相色谱法测定水中多环芳烃(PAHs)的研究

建立了用膜-柱串联固相萃取(SPE)技术,甲醇和水作为流动相进行梯度洗脱,紫外和荧光检测器串联的高效液相色谱法(HPLC)分析水中EPA优先监控的16种PAHs的方法.     

固相萃取富集高效液相色谱法测定环境水样中的重金属元素

研究了用固相萃取富集高效液相色谱法测定环境水样中痕量重金属镍、铜、银、铅、镉和汞的方法。环境水样中的镍、铜、银、铅、镉和汞用四 -(对二甲氨基苯基 ) -卟啉 (T4 -DMAPP)柱前衍生 ,用C18固相萃取小柱萃取富集镍、铜、银、铅、镉和汞的T4 -DMAPP络合物 ,富集倍数为 1 0 0倍 ,然后用甲醇和四氢呋喃梯度洗脱为流动相 ,WatersXter raTMRP18( 3 9mm× 1 5 0mm)色谱柱为固定相分离 ,用二极管矩阵检测器检测。镍、铜、银、铅、镉和汞的检测限分别为3、2、4、3、1 5ng/L和 3ng/L。方法相对标准偏差为 1 8%— 3 2 % ,标准回收率为 92 %— 1 0 7%。该方法用于测定环境水样中的痕量重金属 ,结果令人满意