氮磷检测器在环境痕量有机污染物分析中的应用

介绍了氮磷检测嚣(NPD)的性能和特点,以及在环境微量或超微量有机分析中的应用.比较了含氮、磷物质在NPD及其它检测器上的灵敏度和精密度,发现NPD上的灵敏度要明显高于火焰光度检测器(FPD)和氢火焰检测器(FID).因此,NPD作为一种高灵敏度、高选择性的检测嚣,在含氮磷的有机污染物监测中的作用越来越重要,尤其在环境评价及环境本底调查中的超微量分析中,将逐步取代FID和FPD而发挥其优越的检测特性.     

废水中的丙溴磷气相色谱分析

试验了废水中的丙溴磷气相色谱分析方法。以大口径毛细管柱分离废水中的丙溴磷，分别采用氮磷检测器（NPD）和电子捕获检测器（ECD）检测，得到了良好的分离效果和较高的灵敏度，方法检测限为0．002mg/L(绝对检测量最低可达2pg,NPD)和0.0008mg/L(绝对检测量最低可达0．8pg,ECD)。该方法中，采用双柱双检测器，排除了误检和其他物质的干扰，保证了分析结果的可靠性。     

顶空毛细柱气相色谱法测定水中硝基苯类化合物

硝基苯类国内外一般均采用有机溶剂萃取后气相色谱法分析,在GC条件选择上用FID、ECD两种检测器和填充柱、毛细柱两种柱型.溶剂萃取法虽然富集倍数大,但选择性较差.给GC分离带来困难且所用的芳烃溶剂毒性较     

气相色谱法测定环境空气中三甲胺

采用4%聚乙二醇(PEG)-20M+1%KOHGXD-401为固定相,2m×3mm玻璃填充柱分离三甲胺,FID检测。该方法有较高灵敏度和良好的线性关系。结果表明:在柱温140℃,进样口温度180℃,检测器温度180℃,氮流量30mL/min时,平均回收率为100 3%,相对标准差为3%。     

水中酚类优先监测物的气相色谱测定法

介绍测定环境水质中重点酚类污染物的色谱法,应用衍生化的前处理方法,分别采用填充柱和毛细管柱分离,氢焰检测器(FID)和电子捕获检测器(ECD)测定使用美国EPA的质量控制样品(QC),确定了方法的精密度和准确度.     

NPD与FPD气相色谱法测定水中的黄磷

实验采用优化条件,对甲苯萃取水和废水中黄磷进行测定。萃取液经气相色谱仪毛细色谱柱分离后,氮磷检测器（NPD）或火焰光度检测器（FPD,带磷滤光片）检测,根据色谱峰的保留时间定性,外标法定量。使用NPD检测器分析时,本方法检出限为0.04μg/L;使用FPD检测器分析时,本方法检出限为0.1μg/L。     

毛细管柱气相色谱法测定有组织废气中氯乙烯

利用毛细管柱对有组织废气中氯乙烯进行分离,火焰离子化检测器(FID)进行检测,建立了有组织废气中氯乙烯的毛细管柱气相色谱测定法。该方法检出限为0.08 mg/m~3,空白样品加标回收率为98.6%~99.9%,变异系数为0.96%~1.24%。实验结果表明,该方法准确可靠、灵敏度好、分析速度快、操作简便,适用于有组织废气中氯乙烯的测定。     

吡啶的气相色谱分析

试验了以气相色谱法、大口径弹性石英毛细管柱分离 ,NPD检测环境样品中吡啶 ,得到了良好的分离效果 ,峰形好 ,并有较高的灵敏度和较宽的线性范围 ,检测限可达 0 0 0 4mg/L ,完全能满足环境空气质量分析和水质分析的要求。     

火焰光度气相色谱法测定水中的黄磷

采用正己烷萃取，大口径毛细管柱分离，火焰光度检测器（FPD）气相色谱法检测黄磷，得到了良好的分离效果、较宽的线性关系和较高的灵敏度．由于采用高灵敏度专业检测器FPD检测，避免了不含磷物质的干扰，方法的检出浓度可达0．0001mg／L．     

有机酸的快速硅烷化气相色谱分析

本方法采用三甲基氯硅烷与有机酸在吡啶中室温反应,直接进GC分析测定。脂肪酸和芳香酸、一元酸和二元酸共七种有机酸在SE—30填充柱上(FID)得到了很好的分离。最低检测量10~(-8)～10~(-9)。     

Use of a non-planning driving background change methodology to assess the land-use planning impact on the environment

The implementation of land-use planning (LUP) impacts on the environment and may degrade regional environmental quality due to the changes in land-use patterns. To minimize the environmental impact of non-LUP driven (NPD) land-use background changes (LUBC), we propose an NPD land-use background change (NPD-LUBC) methodology to improve the LUP environmental impact assessment (LUPEA) process. With the application of the state-impact-state (SIS) framework and spatial information technologies including remote sensing and geographic information system (GIS), the methodology was tested on the eastern Chinese city of Lianyungang. The results indicate that (1) our proposed methodology is capable of distinguishing the environmental impact in implementing a target LUP, i.e. a LUP scheme to be assessed, from those driven by NPD-LUBC; (2) the prediction of NPD Land-use pattern simulated through the discrimination of NPD forces provides the basic data to support the LUPEA using our proposed methodology; (3) SO₂, PM₁₀, and COD emitted into the atmosphere and water are the major pollutants considered in the LUPEA of the city; and (4) despite the positive impacts of the comprehensive land-use change under the direction of target LUP, the implementation of LUP would have negative impacts on the regional environment in the entire study area and in individual counties/districts respectively in 2020. Our proposed methodology provides a new and operable way for the areas with data to simulate NPD land-use pattern and predict the individual indicator values for the assessment.     

空气或废气中挥发性醛、酮的气相色谱法测定

本文研究采用了空气或废气中挥发性醛、酮类化合物在常温下经２，４二硝基苯肼（ＤＮＰＨ）的酸性饱和溶液吸收，分别形成各自的腙，用ＣＳ２萃取后，经气相色谱法（ＧＣＦＩＤ）以３％ＳＥ３０／ＣｈｒｏｍｏｓｏｒｂＷＨＰ８０１００目为固定相和载体，分离测定，对空气或废气中的甲醛、乙醛、丙烯醛、丁醛、丙酮、丁酮、甲基异丁基酮等的测定，获得较满意的结果。     

气相色谱法测定水和废水中丙烯腈

本文通过采用气相色谱法，以ＧＤＸ－５０２为固定相，ＦＩＤ为检测器测定水和废水中的丙烯腈，精密度和回收率高．方法简便易行，能满足行业废水和地面水的监队是水和废水中丙烯腈分析的较理想方法。     

激光散射法和便携式氢火焰离子化检测器法直读监测油烟排放

餐饮业油烟排放具有排放浓度不稳定、波动较大、排放时间短等特性，存在瞬时排放高值现象，油烟"看得见"和"闻得着"的问题依然存在，因此对油烟实现快速、及时、直读监测尤为必要。基于一种浓度可控且稳定的油烟产生技术，对直读激光散射法与经典手工称重法测定油烟颗粒物浓度值的数据线性关系进行了分析，发现2种方法数值的相关系数达0.99，通过直读修正激光散射法可以有效地测定油烟颗粒物浓度，并测定了不同水汽含量下油烟颗粒物排放情况，发现当相对湿度超过70%时，油烟颗粒物浓度测定值会发生突变。使用便携式氢火焰离子化检测器法（FID）和光离子化检测器法（PID）测定了不同油温下油烟中非甲烷总烃（NMHC）浓度，发现FID对油烟中NMHC的变化反应及时，能够较好地测定油烟中挥发性有机物的排放量。     

Determination of resin acids during production of wood pellets--a comparison of HPLC/ESI-MS with the GC/FID MDHS 83/2 method

Resin acids are constituents of natural and technical products of widespread use. Exposure is known to cause health effects in the airways and on the skin. Liquid chromatography/positive ion electrospray-mass spectrometry (HPLC/pos ESI-MS) was investigated for determination of 7-oxodehydroabietic (7-OXO), dehydroabietic (DHAA) and abietic acid (AA) in wood dust-containing air samples as a derivatisation-free alternative to the GC/FID HSE method 83/2, developed by the Health and Safety Executive UK. The resin acid 7-OXO was measured as a marker for oxidised resin acids, which are known to be the main contact allergens in colophonium. The found detection limits were 0.42 ng m(-3) for 7-OXO, 5.2 ng m(-3) for DHAA and 9.4 ng m(-3) for AA, respectively, which are considerably lower than with the GC/FID method (24, 115 and 89 ng m(-3)). The two methods correlated well, although consistently and significantly lower concentrations of 7-OXO were detected with LC/MS. The higher concentration of this compound with MDHS 83/2 is suggested to be an artefact from the derivatisation step in the presence of soluble wood dust remains.     

硅胶管采样—气相色谱测定环境空气中苯胺类化合物

研究并建立了环境空气中7种苯胺类化合物经硅胶管吸附、甲醇解吸、气相色谱氮磷检测器检测方法。研究结果显示：当采集10 L气体时,该方法检出限为0.0059-0.0129 mg/m^3（进样量为1.0μl时）。采集样品密闭、低温可保存3 d。该方法可有效提高检出限、精密度,回收率均满足环境监测要求。     

GC/FTIR-FID测定石化废水中挥发性有机物

所述石化废水中挥发性有机物分析方法 ,以 GC分离 ,FTIR定性 ,FID定量。水样前处理采用大吹脱体积 ,两级捕集的吹脱捕集技术。为解决剖析分析无标样定量问题 ,成功地实现了 GC/FTIR-FID匹配联机 ,使得未知组分定性定量一次完成。方法变异系数低于 5% ,回收率高于 90 % ,最低检出浓度可达 0 .0 0 5mg/L     

Environmental and biological monitoring of methyl ethyl ketone (MEK)

This study was conducted to evaluate the usefulness of various biological parameters for monitoring of workers exposed to methyl ethyl ketone (MEK). Fifty male workers from a large magnetic videotape factory participated in this study. Personal air samples were collected using 3M organic vapor monitors and analysed for MEK by gas chromatography with flame ionisation detector (FID). 10 mL of urine; blood (1 mL) and exhaled air were also collected at the end of an 8-hour workshift. The headspace GC method was applied for measurement of urinary and blood MEK. MEK in expired air was analysed directly by using a GC/FID.The correlation coefficients (r) between environmental MEK and all other biological parameters measured show significant positive relationships. The r for environmental MEK and urine MEK was 0.84; for blood 0.73 and for breath 0.64. The correlation coefficients between blood and urine was 0.72; blood and breath was 0.88 and urine and breath 0.60. These findings suggest that measurements of unmetabolised MEK in blood, exhaled air and urine can be used for biological monitoring of MEK exposure. Nevertheless, laboratory methodological assessment is in favour of measuring urinary MEK as it is non-invasive and does not have to be analysed immediately after collection.