Concentrations and analysis of health risks of ambient air metallic elements at Longjing site in central Taiwan

Environmental Geochemistry and Health - The concentrations of particulates and metallic elements that were bound to total suspended particulates in ambient air at Long Cyuan Elementary School...     

Arsenic accumulation by two brake ferns growing on an arsenic mine and their potential in phytoremediation

In an area near an arsenic mine in Hunan Province of south China, soils were often found with elevated arsenic levels. A field survey was conducted to determine arsenic accumulation in 8 Cretan brake ferns (Pteris cretica) and 16 Chinese brake ferns (Pteris vittata) growing on these soils. Three factors were evaluated: arsenic concentration in above ground parts (fronds), arsenic bioaccumulation factor (BF; ratio of arsenic in fronds to soil) and arsenic translocation factor (TF; ratio of arsenic in fronds to roots). Arsenic concentrations in the fronds of Chinese brake fern were 3-704 mg kg-1, the BFs were 0.06-7.43 and the TFs were 0.17-3.98, while those in Cretan brake fern were 149-694 mg kg-1, 1.34-6.62 and 1.00-2.61, respectively. Our survey showed that both ferns were capable of arsenic accumulation under field conditions. With most of the arsenic being accumulated in the fronds, these ferns have potential for use in phytoremediation of arsenic contaminated soils.     

Arsenic accumulation by ferns: a field survey in southern China

The objective of this study reported here was to characterize arsenic (As) accumulation by Pteris ferns by comparing 3 of the ferns of this genus with each other as well as with four non-Pteris ferns growing on seven sites in southern China with different As levels. A total of 112 samples, including 78 Pteris vittata, 13 P. cretica, 3 P. multifida and 18 ferns from other non-Pteris genera, with the soils in which they grew were collected for As and other elemental analyses. P. vittata was found to be the most dominant species and the most efficient As-accumulator, whereas P. multifida was the lowest As-accumulator among the Pteris ferns, with 4.54–3599, 28.7–757 and 11.2–341 mg kg^–1 As recorded in the fronds of P. vittata, P. cretica and P. multifida, respectively. Arsenic concentrations in non-Pteris ferns were generally much lower than those in Pteris ferns, with 0.81–1.32, 3.59, 10.7, 6.17–24.3 mg kg^–1 in the fronds of Blechumum orientale, Dicranopteris dichotoma, Pteridium aquilinum and Cyclosorus acuminatus, respectively. For P. vittata, the As bioaccumulation factor (ratio of As in fronds to that in soils) changed, whereas the As translocation factor (ratio of As in fronds to that in roots) remained unchanged among the different sites. The concentrations of Fe were very high in all of the collected fern sample, with the exception of B.␣orientale, with 207–6865, 637–3369, 375–1856, 1876, 493-6865 and 492 mg kg^–1 in the fronds of P. vittata, P. cretica, P. multifida, C. acuminatus, P. aquilinum and D. dichotoma, respectively. The association between Fe accumulation and As accumulation and tolerance in these ferns indicates the unique role of Fe in As-hyperaccumulation.     

PM<Subscript>2.5</Subscript> particulates and metallic elements (Ni,Cu, Zn,Cd and Pb) study in a mixed area of summer season in Shalu,Taiwan

PM_2.5 has become an important environmental issue in Taiwan during the past few years. Moreover, electricity increased significantly during the summertime and TTPP generated by coal burning base is the main electricity provider in central Taiwan. Therefore, summer season has become the main research target in this study. The ambient air concentrations of particulate matter PM_2.5 and PM₁₀ collected by using VAPS at a mixed characteristic sampling site were studied in central Taiwan. The results indicated that the average daytime PM_2.5 and PM₁₀ particulate concentrations were occurred in May and they were 44.75 and 57.77 µg/m³ in this study. The results also indicated that the average nighttime PM_2.5 and PM₁₀ particulate concentrations were occurred in June and they were 38.19 and 45.79 µg/m³ in this study. The average PM_2.5/PM₁₀ ratios were 0.7 for daytime, nighttime and 24-h sampling periods in the summer for this study. This value was ranked as the lowest ratios when compared to the other seasons in previous study. Noteworthy, the results further indicated that the metallic element Pb has the mean highest concentrations for 24-h, daytime and nighttime sampling periods when compared to those of the other metallic elements (Ni, Cu, Zn and Cd). The average mean highest metallic Pb concentrations in PM10 were 110.7, 203.0 and 207.2 ng/m³ for 24-h, daytime and nighttime sampling periods in this study. And there were 59.53, 105.2 and 106.6 ng/m³ for Pb in PM2.5 for 24-h, daytime and nighttime sampling periods, respectively. Moreover, the results further indicated that mean metallic element Pb concentrations on PM_2.5 and PM₁₀ were all higher than those of the other elements for 24 h, day and nighttime.     

Ambient air particulates-bound metallic elements sources identifications during winter and summer at a Science Park

The ambient air particulates pollutants of total suspended particulates (TSP) and PM_2.5 were collected by using PS-1 and Wilbur PM_2.5 sampler, simultaneously during the year of 2015–2017 at a photoelectric factory in Science Park of central Taiwan. And those of the ambient air atmospheric metallic elements (Cr, Mn, Ni, Cu, Zn, Pb) concentrations which attached on the TSP and PM_2.5 were analyzed by using inductively coupled plasma optical emission spectrometer. In addition, identifying anthropogenic and natural pollutants sources were conducted by using the enrichment factor (EF) and principal component analysis (PCA) methods. The results indicated that the average TSP and PM_2.5 concentrations were ranked highest in winter season, while summer season was ranked lowest during the year of 2015–2016. In addition, the average highest metallic element concentrations were occurred in winter season for both TSP and PM_2.5 during the year of 2015–2016, while the average lowest metallic elements concentrations in TSP and PM_2.5 were also occurred in winter season during the year of 2016–2017. Moreover, the EF analysis results showed that the metallic element Zn came from anthropogenic emission source. As for metallic element Mn, the results showed that metallic element Mn was mainly attributed to natural emission in this study. Finally, the PCA results showed that metallic elements Cr, Zn and Pb were the dominant emissions metallic elements in this study. As for PM_2.5, the results showed that the metallic elements Cr, Cu and Pb were the dominant emissions metallic elements at this HPB sampling site.

     

Elutriation characteristics of fine particles from bubbling fluidized bed incineration for sludge cake treatment

In this study, measurements of elutriation rate were carried out in a bench scale bubbling fluidized bed incinerator, which was used to combust sludge cake. The particle size distribution and ignition loss were analyzed to study the elutriation characteristics of bubbling fluidized bed incineration. Drawn from the experimental data, the elutriation rate constant K(i)* for fine particles were obtained and correlated with parameters. It was found that most of the solid particles (about 95%) elutriated came from the fluidized medium (inorganic matters), but few came from unburned carbon particles or soot (about 5%). Finally, this paper lists a comparison of K(i)* between this study and the published prediction equations derived or studied in non-incineration modes of fluidized bed. A new and modified correlation is proposed here to estimate the elutriation rate of fine particles emitted from a bubbling fluidized bed incinerator. Primary operation variables (superficial gas velocity and incineration temperature) affecting the elutriation rate are also discussed in the paper.     

Review of total suspended particles (TSP) and PM<Subscript>2.5</Subscript> concentration variations in Asia during the years of 1998–2015

In Asian countries such as China, Malaysia, Pakistan, India, Taiwan, Korea, Japan and Hong Kong, ambient air total suspended particulates and PM_2.5 concentration data were collected and discussed during the years of 1998–2015 in this study. The aim of the present study was to (1) investigate and collect ambient air total suspended particulates (TSP) and PM_2.5 concentrations for Asian countries during the past two decades. (2) Discuss, analyze and compare those particulates (TSP and PM_2.5) annual concentration distribution trends among those Asian countries during the past two decades. (3) Test the mean concentration differences in TSP and PM_2.5 among the Asian countries during the past decades. The results indicated that the mean TSP concentration order was shown as China > Malaysia > Pakistan > India > Taiwan > Korea > Japan. In addition, the mean PM_2.5 concentration order was shown as Vietnam > India > China > Hong Kong > Mongolia > Korea > Taiwan > Japan and the average percentages of PM_2.5 concentrations for Taiwan, China, Japan, Korea, Hong Kong, Mongolia and Other (India and Vietnam) were 8, 21, 6, 8, 14, 13 and 30%, respectively, during the past two decades. Moreover, t test results revealed that there were significant mean TSP and PM_2.5 concentration differences for either China or India to any of the countries such as Taiwan, Korea and Japan in Asia during the past two decades for this study. Noteworthy, China and India are both occupied more than 60% of the TSP and PM_2.5 particulates concentrations out of all the Asia countries. As for Taiwan, the average PM_2.5 concentration displayed increasing trend in the years of 1998–1999. However, it showed decreasing trend in the years of 2000–2010. As for Korea, the average PM_2.5 concentrations showed decreasing trend during the years of 2001–2013. Finally, the average PM_2.5 concentrations for Mongolia displayed increasing trend in the years of 2004–2013.     

Comparisons of particulate-bound mercury (PBM) compositions in soil and vegetation at a traffic site

This investigation analyzes the particulate-bound mercury (PBM) compositions in soil and vegetation at a traffic sampling site in Taichung, Taiwan, during a sampling period from October to December, 2015. A direct mercury analyzer (DMA-80) was used to measure the particulate-bound mercury (PBM). A T-test was conducted to determine the mean differences between the PBM composition in soil and that in vegetation at the site. The results indicate that 1) the mean particulate-bound mercury compositions in soil and vegetation were the lowest in November, when the (mean OR average) wind speed was the highest (4.1 m/s); 2) Particulate-bound mercury compositions (PBM) in both soil and vegetation correlated weakly with temperature, humidity and wind speed; 3) T-test statistical results denoted that the PBM compositions did not significantly differ between soil and vegetation in the three-month sampling period.     

Annual ambient atmospheric mercury speciation measurement from Longjing,a rural site in Taiwan

The main purpose of this study was to monitor ambient air particulates and mercury species [RGM, Hg(p), GEM and total mercury] concentrations and dry depositions over rural area at Longjing in central Taiwan during October 2014 to September 2015. In addition, passive air sampler and knife-edge surrogate surface samplers were used to collect the ambient air mercury species concentrations and dry depositions, respectively, in this study. Moreover, direct mercury analyzer was directly used to detect the mercury Hg(p) and RGM concentrations. The result indicated that: (1) The average highest RGM, Hg(p), GEM and total mercury concentrations, and dry depositions were observed in January, prevailing dust storm occurred in winter season was the possible major reason responsible for the above findings. (2) The highest average RGM, Hg(p), GEM and total mercury concentrations, dry depositions and velocities were occurred in winter. This is because that China is the largest atmospheric mercury (Hg) emitter in the world. Its Hg emissions and environmental impacts need to be evaluated. (3) The results indicated that the total mercury ratios of Kaohsiung to that of this study were 5.61. This is because that Kaohsiung has the largest industry density (~60 %) in Taiwan. (4) the USA showed average lower mercury species concentrations when compared to those of the other world countries. The average ratios of China/USA values were 89, 76 and 160 for total mercury, RGM and Hg(p), respectively, during the years of 2000–2012.     

Change in MSW characteristics under recent management strategies in Taiwan

Reduction and recycling initiatives such as producer responsibility and pay-as-you-throw are being implemented in Taiwan. This paper presents a study assessing the impact of recently implemented municipal solid waste (MSW) reduction and recycling management strategies on the characteristics of waste feedstock for incineration in Taiwan. Through the periodic sampling of two typical MSW incineration plants, proximate and ultimate analyses were conducted according to standard methods to explore the influence of MSW reduction and recycling management strategies on incineration feed waste characteristics. It was observed that the annual amount of MSW generated in 2005 decreased by about 10% compared to 2003 and that the characteristics of MSW have changed significantly due to recent management strategies. The heating value of the MSW generated in Taiwan increased yearly by about 5% after program implementation. A comparison of the monthly variations in chemical concentrations indicated that the chlorine content in MSW has changed. This change results from usage reduction of PVC plastic due to the recycling fund management (RFM) program, and the food waste as well as salt content reduction due to the total recycling for kitchen garbage program. This achievement will improve the reduction of dioxin emissions from MSW incineration. In summary, management strategies must be conducted in tandem with the global trend to achieve a zero-waste-discharge country. When implementing these strategies and planning for future MSW management systems, it is important to consider the changes that may occur in the composition and characteristics of MSW over time.