Correction to: Keeping pace with forestry: Multi-scale conservation in a changing production forest matrix

Ambio - In the original published article, the sentence “Nevertheless, semi-natural forest remnants continue to be harvested and fragmented (Svensson et al. 2018; Jonsson et al. 2019), and...     

The tree species matters: Biodiversity and ecosystem service implications of replacing Scots pine production stands with Norway spruce

Ambio - The choice of tree species used in production forests matters for biodiversity and ecosystem services. In Sweden, damage to young production forests by large browsing herbivores is helping...     

Multiple mate choice criteria and the importance of age for male mating success in the microhylid frog, Cophixalus ornatus

We examined multiple mate choice criteria in Cophixalus ornatus, a terrestrial breeding, microhylid frog. Mate choice consisted of three stages: mate attraction (male calling), courtship (male behavior between the call site and the nest), and nest site selection by the female. For male C. ornatus, the possession of a call with low dominant frequency relative to calling neighbors increased the probability that they would attract females. Dominant frequency was negatively correlated with age independent of male mass and snout vent length. When escorting the female from the call site to their nest, males traveled along more convoluted paths than when returning to the nest alone. The convolution of the path was, therefore, considered an aspect of courtship. Females released eggs into nests with structural characteristics typical of nests constructed by older males. Thus, females increased their chances of locating an acceptable nest by preferentially approaching males with lower dominant frequencies. This study is the first to demonstrate that age, independent of mass or snout-vent length, can influence call characteristics in anurans, and it is also the first to demonstrate the importance of male age to female mate choice in an amphibian.     

New York State urban and rural measurements of continuous PM2.5 mass by FDMS, TEOM, and BAM

Field evaluations and comparisons of continuous fine particulate matter (PM2,5) mass measurement technologies at an urban and a rural site in New York state are performed. The continuous measurement technologies include the filter dynamics measurement system (FDMS) tapered element oscillating microbalance (TEOM) monitor, the stand-alone TEOM monitor (without the FDMS), and the beta attenuation monitor (BAM). These continuous measurement methods are also compared with 24-hr integrated filters collected and analyzed under the Federal Reference Method (FRM) protocol. The measurement sites are New York City (the borough of Queens) and Addison, a rural area of southwestern New York state. New York City data comparisons between the FDMS TEOM, BAM, and FRM are examined for bias and seasonality during a 2-yr period. Data comparisons for the FDMS TEOM and FRM from the Addison location are examined for the same 2-yr period. The BAM and FDMS measurements at Queens are highly correlated with each other and the FRM. The BAM and FDMS are very similar to each other in magnitude, and both are approximately 25% higher than the FRM filter measurements at this site. The FDMS at Addison measures approximately 9% more mass than the FRM. Mass reconstructions using the speciation trends network filter data are examined to provide insight as to the contribution of volatile species of PM2.5 in the FDMS mass measurement and the fraction that is likely lost in the FRM mass measurement. The reconstructed mass at Queens is systematically lower than the FDMS by approximately 10%.     

Avoiding the pitfalls of adaptive management implementation in Swedish silviculture

There is a growing demand for alternatives to Sweden’s current dominant silvicultural system, driven by a desire to raise biomass production, meet environmental goals and mitigate climate change. However, moving towards diversified forest management that deviates from well established silvicultural practices carries many uncertainties and risks. Adaptive management is often suggested as an effective means of managing in the context of such complexities. Yet there has been scepticism over its appropriateness in cases characterised by large spatial extents, extended temporal scales and complex land ownership—characteristics typical of Swedish forestry. Drawing on published research, including a new paradigm for adaptive management, we indicate how common pitfalls can be avoided during implementation. We indicate the investment, infrastructure, and considerations necessary to benefit from adaptive management. In doing so, we show how this approach could offer a pragmatic operational model for managing the uncertainties, risks and obstacles associated with new silvicultural systems and the challenges facing Swedish forestry.     

Keeping pace with forestry: Multi-scale conservation in a changing production forest matrix

The multi-scale approach to conserving forest biodiversity has been used in Sweden since the 1980s, a period defined by increased reserve area and conservation actions within production forests. However, two thousand forest-associated species remain on Sweden’s red-list, and Sweden’s 2020 goals for sustainable forests are not being met. We argue that ongoing changes in the production forest matrix require more consideration, and that multi-scale conservation must be adapted to, and integrated with, production forest development. To make this case, we summarize trends in habitat provision by Sweden’s protected and production forests, and the variety of ways silviculture can affect biodiversity. We discuss how different forestry trajectories affect the type and extent of conservation approaches needed to secure biodiversity, and suggest leverage points for aiding the adoption of diversified silviculture. Sweden’s long-term experience with multi-scale conservation and intensive forestry provides insights for other countries trying to conserve species within production landscapes.

     

Comparison of current Federal Reference Methods for ambient lead measurements adjacent to a secondary lead smelter

The United States Environmental Protection Agency (EPA) reduced their National Ambient Air Quality Standard (NAAQS) for lead (Pb) an order of magnitude to a concentration level of 0.15 micrograms per cubic meter (µg/m³) when the new rule was promulgated in 2008. At that time, the possibility of revising the Pb sampling method from total suspended particulate (TSP) to particulate matter less than or equal to 10 µm in diameter (PM₁₀) was considered due to potential measurement bias of the Pb-TSP monitoring technique. The New York State Department of Environmental Conservation (NYSDEC) has been operating source-orientated colocated TSP and PM₁₀ monitors documenting ambient air lead (Pb) concentrations since 2011 at a site adjacent to a secondary Pb smelter in Wallkill, New York. The colocated Wallkill data show a very strong correlation between the readings recorded by these two sampling techniques. After the range of the variability in the individual Pb-PM₁₀/Pb-TSP ratios was reduced by using a 0.005 µg/m³ concentration cut point, because of the concerns about the measurements at low concentrations, an adjustment factor (AF) of 1.49 was calculated using the remaining data set. This AF can be used to estimate Pb-TSP concentrations from Pb-PM₁₀ readings at this Wallkill source-orientated location. It was stated by the EPA that there is only a limited data set in situations where Pb-TSP and Pb-PM₁₀ are colocated, especially for those sites considered to be source-oriented, so the analyses performed and summarized herein for the Wallkill colocated airborne Pb concentration data add to that limited data set.

Implications: These data analyses add to the limited data set in situations where Pb-TSP and Pb-PM₁₀ are colocated to help refine the derivation of a site-specific adjustment factor for estimating TSP Pb concentrations from measured PM₁₀ Pb concentrations. This could assist the EPA in transitioning away from the use of the Pb-TSP monitoring technique, with its indicated measurement bias, for the Pb NAAQS to the use of Pb-PM₁₀ instead. An adjustment factor of 1.49 was calculated that could be used to estimate Pb-TSP concentrations from Pb-PM₁₀ values collected around this source-orientated location.     

Mixed-function oxidase-specific activity in wild and caged speckled sanddabs Citharichthys stigmaeus in Elkhorn Slough, Moss Landing Harbor and nearshore Monterey Bay, California

The goal of this study was to characterize the spatial, seasonal and annual hepatic activities of mixed-function oxidase (MFO) in the speckled sanddab Citharichthys stigmaeus, the most common fish in the Moss Landing area. In addition, techniques to monitor MFO activities in caged speckled sanddabs were developed and tested. Once the relationship between MFO activities in caged and wild fish populations is determined, caged fish could be used to monitor potential hydrocarbon impacts at Moss Landing, or other marine sites. During each of the spatial, seasonal and annual sediment samplings conducted in 1985-1987 as part of a separate hydrocarbon variability study at Moss Landing, 12 wild speckled sanddabs were collected from Moss Landing Harbor, Elkhorn Slough and nearshore Monterey Bay sites. In addition, four locations were chosen for a 14-day field caged fish experiment. The caged fish experiments successfully demonstrated the feasibility of using caged sanddabs as indicators of hydrocarbon exposure. The major source of variability in hepatic aryl hydrocarbon hydroxylase activity in wild speckled sanddabs from the Moss Landing area is due to seasonal rather than site differences. Significant relationships between caged fish MFO response and sediment hydrocarbon concentrations were found. It is possible that caged fish could be used in place of costly sediment sampling and analysis, and provide a more direct method to assess biological impacts. Many of the caging techniques demonstrated in this study can easily be transferred to other benthic flatfish, and other marine and freshwater environments.     

Semicontinuous PM2.5 sulfate and nitrate measurements at an urban and a rural location in New York: PMTACS-NY summer 2001 and 2002 campaigns

Several collocated semicontinuous instruments measuring particulate matter with particle sizes < or =2.5 microm (PM2.5) sulfate (SO4(2-)) and nitrate (NO3-) were intercompared during two intensive field campaigns as part of the PM2.5 Technology Assessment and Characterization Study. The summer 2001 urban campaign in Queens, NY, and the summer 2002 rural campaign in upstate New York (Whiteface Mountain) hosted an operation of an Aerosol Mass Spectrometer, Ambient Particulate Sulfate and Nitrate Monitors, a Continuous Ambient Sulfate Monitor, and a Particle-Into-Liquid Sampler with Ion Chromatographs (PILS-IC). These instruments provided near real-time particulate SO4(2-) and NO3- mass concentration data, allowing the study of particulate SO4(2-)/NO3- diurnal patterns and detection of short-term events. Typical particulate SO4(2-) concentrations were comparable at both sites (ranging from 0 to 20 microg/m3), while ambient urban particulate NO3- concentrations ranged from 0 to 11 microg/m3 and rural NO3- concentration was typically less than 1 microg/m3. Results of the intercomparisons of the semicontinuous measurements are presented, as are results of the comparisons between the semicontinuous and time-integrated filter-based measurements. The comparisons at both sites, in most cases, indicated similar performance characteristics. In addition, charge balance calculations, based on major soluble ionic components of atmospheric aerosol from the PILS-IC and the filter measurements, indicated slightly acidic aerosol at both locations.     

Varying rotation lengths in northern production forests: Implications for habitats provided by retention and production trees

Because of the limited spatial extent and comprehensiveness of protected areas, an increasing emphasis is being placed on conserving habitats which promote biodiversity within production forest. For this reason, alternative silvicultural programs need to be evaluated with respect to their implications for forest biodiversity, especially if these programs are likely to be adopted. Here we simulated the effect of varied rotation length and associated thinning regimes on habitat availability in Scots pine and Norway spruce production forests, with high and low productivity. Shorter rotation lengths reduced the contribution made by production trees (trees grown for industrial use) to the availability of key habitat features, while concurrently increasing the contribution from retention trees. The contribution of production trees to habitat features was larger for high productivity sites, than for low productivity sites. We conclude that shortened rotation lengths result in losses of the availability of habitat features that are key for biodiversity conservation and that increased retention practices may only partially compensate for this. Ensuring that conservation efforts better reflect the inherent variation in stand rotation lengths would help improve the maintenance of key forest habitats in production forests.